Notice AEG DK 4390-m

Notice AEG DK 4390-m disponible gratuitement après inscription

Accédez à la notice du AEG DK 4390-m en adhérant à la communauté.

Notice d’utilisation de votre AEG DK 4390-m. La notice vous renseigne sur l’utilisation, donne des solutions aux problèmes d’entretien, de fonctionnement et d’assistance pour votre DK 4390-m.

Notices - manuels - modes d'emploi disponibles pour AEG DK 4390-m après inscription au groupe d'entraide

Aperçu de la notice

Extrait de la notice

ains connection) or if the plug is not located in an accessible area, after installation, apply a double pole switch in accordance with standards which assures the complete disconnection of the mains under conditions relating to over-current category III, in accordance with installation instructions. Warning! Before re-connecting the hood circuit to the mains supply and checking the efficient function, always check that the mains cable is correctly assembled. Operation The hood is fitted with a control panel with aspiration speed selection control and a light switch to control cooking area lights. Use the high suction speed in cases of concentrated kitchen vapours. It is recommended that the cooker hood suction is switched on for 5 minutes prior to cooking and to leave in operation during cooking and for another 15 minutes approximately after terminating cooking. Maintenance ATTENTION! Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at the connector and removing the connector fuse. Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket. The cooker hood should be cleaned regularly (at least with the same frequency with which you carry out maintenance of the fat filters) internally and externally. Clean using the cloth dampened with neutral liquid detergent. Do not use abrasive products. DO NOT USE ALCOHOL! WARNING: Failure to carry out the basic cleaning recommendations of the cooker hood and replacement of the filters may cause fire risks. Therefore, we recommend oserving these instructions. The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to in...

En cours...