he battery icon on the LCD screen will show the battery is charging.5 EN Getting Started 2 Allow the battery to charge. Charging time: Approximately 4 hours for a full charge. When the battery is fully recharged, the battery icon is shown as full. WARNING During the recharging process, it is typical for the battery to become warm. To be safe, keep ?ammable materials away from the speaker system. How to Disconnect the Rechargeable Battery 1 Unplug the inMotion Classic from the wall outlet. 2 Remove the rechargeable battery compartment cover at the back of the system by removing the screw. 3 Unplug the battery and remove it. WARNING There is a danger of explosion if the battery is incorrectly replaced. Replace it only with the same or equivalent type. Do not expose it to excessive heat such as sunshine, ?re, etc. BATTERY DISPOSAL The battery used in this product must be properly recycled or disposed of. Please contact your local recycling center for proper battery handling and disposal instructions. Rated Voltage: 3.7V Capacity: 1800mAh Type: McR18650 How to Install the Full-featured Remote Battery The full-featured remote battery (included) is not installed at the factory. To install the battery, follow the steps below: 1 Pull out the battery holder. The battery door is located on the lower end of the remote. Simply pull the tab to open the battery holder. 2 Position the included lithium coin battery (CR2025) battery so it sits in the battery holder correctly. Make sure the polarity (the + and – sides of the battery) is correct. 3 Replace the battery door. NOTE Please discard used batteries properly.6 Placing and Removing Adapters for the iPhone and iPod Your Altec Lansing inMotion Classic speaker system includes removab...