Notice ALTEC LANSING VS2221

Notice ALTEC LANSING VS2221 disponible gratuitement après inscription

Accédez à la notice du ALTEC LANSING VS2221 en adhérant à la communauté.

Notice d’utilisation de votre ALTEC LANSING VS2221. La notice vous renseigne sur l’utilisation, donne des solutions aux problèmes d’entretien, de fonctionnement et d’assistance pour votre VS2221.

Notices - manuels - modes d'emploi disponibles pour ALTEC LANSING VS2221 après inscription au groupe d'entraide

Aperçu de la notice

Extrait de la notice

nnected, the speaker system is muted. VS2221 Three-Piece Powered Audio System3 Sound Pressure Level (SPL):99 dB Total Continuous Power:28 Watts RMS • Front Speakers: 6 Watts/channel @ 4 ohms @ 10% THD @ 150 Hz – 20 kHz 2 Channels Loaded • Subwoofer:16 Watts @ 8 ohms @ 10% THD @ 30 – 150 Hz Single Channel Loaded System Response:35 Hz – 20 kHz (-10 dB) Signal to Noise Ratio @ 1 kHz input:> 75 dB Drivers (per satellite):One 2" full-range driver Subwoofer: One 5.25" woofer System Specifications* Altec Lansing’s superior sound comes from our patented Dynamic EQ technology, which utilizes custom-built, high-fidelity drivers, state-of-the-art equalization circuitry, and a harmonious mix of the following specifications: *Power rating conforms to FTC Amplifier Rule #16 C.F.R. Part 432. No LEDs are lit. No sound fromone or morespeakers. Crackling sound from speakers. Power isn’t turned on. AC power cord isn’t connected to the wall outlet. Surge protector (if used) isn’t powered on. Wall outlet not functioning. Power isn’t turned on. Volume is set too low. 3.5mm stereo cable isn’t connected to audio source. 3.5mm stereo cable is connected to wrong output on audio source. Problem with audio source device. Bad connection. Volume level in computer operating system is set toohigh. A problem with your audio source device. Turn the VOLUME knob on the right speaker until you hear a click sound. An LED will light next to the knob when the power is ON. Check to see if the “Power On” LED is illuminated on the right satellite. If not, connect AC power. If the AC power cord is plugged into a surge protector, make sure the surge protector is switched on. Plug another device into the wall outlet (same jack) to verify the wall outlet isworkin...

En cours...