Notice ALTEC LANSING XA3021 disponible gratuitement après inscription

Extrait de la notice

he subwoofer. Bad connection. Volume on your audio source device set too high. Bass setting is too low. Bad connection. Bass setting is too high. Subwoofer too close to monitor/TV. Try to gently straighten the pins with tweezers or very small pliers. If this does not work, contact the Altec Lansing Consumer Support Department for further instructions. Press the Power button on the wired controller. Disconnect and then reconnect the power adapter to both the wall outlet and the subwoofer. If the power adapter is plugged into a surge protector, make sure the surge protector is switched on. Connect the wired controller to the subwoofer. Plug another device into the same jack on the wall outlet to ensure the outlet is working. Verify that the grey-colored DIN connector is firmly inserted into the DIN connector jack on the subwoofer. Ensure the pins are aligned between the plug and jack. Remember, the arrow should be facing up. Verify that the subwoofer’s AC power cord is plugged into both the wall outlet and subwoofer. Verify that the Power button has been pressed and that an EQ LED is illuminated. Turn the rotary knob to the right to raise the system master volume. Check volume level on the video gaming system or alternate audio source device, and set at mid-level. Connect audio cable from the audio source. Check plug connections on both the subwoofer and audio source. Make sure these signal cables are inserted firmly into the correct jacks. Make sure that a cable connects the output jacks on the audio source to the input jacks on the XA3021’s subwoofer. Test the speakers with another audio source. Check all cables. Make sure they are connected to the “line-out” or “audio-out” jacks on your audio source device. Test the speakers using ano...