Notice BAUKNECHT TK Care 6B disponible gratuitement après inscription

Extrait de la notice

t exchanger at least every month, proceeding as follows: A.Open the door and press the heat exchanger flap button on the bottom of the door entrance. B.The heat exchanger flap opens. C.Fold the heat exchanger handle upwards to the horizontal position and remove the heat exchanger. D.Clean the heat exchanger under running water by turning it around to reach all sides, especially in front and behind. E.Wipe away dust and lint from the seals and the heat exchanger plates. F.Remove the lint in the heat exchanger housing. Keep the drainage hole (left side in front in the housing) free from lint. G.Insert completely the heat exchanger in its housing (TOP or HAUT mark upwards) keeping the handle in horizontal position, and then push down the handle. H.Close the flap. The heat exchanger aluminium plates may become discoloured over time. Note: Depending on the model, the opening of the flap can be horizontal or vertical. This doesn’t change the functioning of the flap. C A B D19 TROUBLESHOOTING GUIDE / AFTER-SALES SERVICE Troubleshooting Guide If a fault occurs, before contacting our After- Sales Service, make the following checks to try and remedy the problem: Drying takes too long / laundry is not dry enough: •Was the correct programme selected? •Was the inserted laundry too wet (Washing machine spin speed less than 800rpm? When the spinning speed is less than 800 rpm the water container fault may occur during the drying cycle)? •Is the lint filter dirty (filter indicator lamp on)? •Is the heat exchanger dirty? (refer to the Instructions for use) •Is the ambient temperature too high? •Are the END and Anti-crease indicator lamps lighting up? The drying cycle is complete and the laundry can be ta...