Notice BLACK & DECKER VN2000 disponible gratuitement après inscription

Extrait de la notice

ximum mark indicated on the bin.9 ENGLISH Remove the container (9) from the appliance by pressing the two release buttons (31) and lifting the container out of the appliance. Press the lower door latch (32) to release the dirt. Empty the container as necessary. Clean the filter as described below. Close the lower door and make sure that it clicks into place. Re-fit the container (9) into the appliance, make sure that the release buttons (31) click into place. Press the filter cleaning switch (3) and the filter cleaning cycle will run for 10 seconds, after which it will automatically switch off. This will ensure that the next time the appliance is used, the performance will be at it's optimum. Cleaning Warning! Before cleaning and maintenance, switch the appliance off and unplug it. From time to time wipe the appliance with a damp cloth. Do not use any abrasive or solvent-based cleaner. Do not immerse the appliance in water. Cleaning the container filters (fig. H - K) The container filters prevent dust and dirt from entering the motor housing. The filters are re-usable and should be cleaned periodically. Remove the container from the appliance (fig. H). Press the lower door latch (32) to release the lower door (fig. I). Remove the pre-filter (33) from the container (9) (fig. J) by rotating anti clockwise. Pull the filter (34) off the filter holder (fig. K). Warning! Do not brush or use compressed air to clean the filter. Depending on its condition, rinse the outside of the filter with water. Allow the filter to dry for 24 hours before reinserting it. Warning! Do not wash the inside of the filter. Replace the filter. Re-fit the pre-filter. Close the lower door. Re-insert the container into the applia...