Notice BRAUN CoolTec disponible gratuitement après inscription

Extrait de la notice

residue! The contacts (7) on the back of the shaver need to align with the contacts (15) in the Clean&Charge station. Push the shaver in the correct position. A beep sound confirms that the shaver sits properly in the station. Charging will start automatically. Cleaning the shaver in the Clean&Charge Station When the cleaning indicator lights up in the shaver display, insert the shaver into the Clean&Charge station, upside down and with the front showing. Start automatic cleaning Start the cleaning process by pressing the start button (17). If the status light (16b) does not shine (Clean&Charge station switches to stand-by after about 10 minutes), press the start button twice. 92388019_CoolTec_NA_S6-36.indd 992388019_CoolTec_NA_S6-36.indd 910.10.12 13:1810.10.12 13:1810 Otherwise cleaning will not start. For best shaving results, we recommend cleaning after each shave. The cleaning program consists of several cycles, where cleaning fluid is flushed through the shaver head. The cleaning time takes 3 minutes. During this time the status light of the Clean&Charge station blinks. Leave the shaver in the station for drying. It takes several hours until remaining moisture evaporates depending on the climatic conditions. Afterwards the shaver is ready for use. After completing the cleaning and charging session, the indicators of the Clean&Charge station turn off. Removing the shaver from the Clean&Charge station (see fig. F) Hold the Clean&Charge station with one hand and tilt the shaver slightly to the front to release it. Cleaning Cartridge / Replacement (see fig. G) When the level indicator lights up permanently red, the remaining fluid in the cartridge is sufficient for about 3 more cycles. When the le...