ne can show if a call was received in you absence by ?ashing the Message Waiting Indicator in standby mode. This function operates differently depending on the PBX in question. Please contact the system controller for more information.English 10 www.doro.com Other System Settings You can select several parameters when connecting the telephone to a PBX. Recall (R) Time Duration (TBR only) This allows you to select TBR recall access timing. The time selected will depend on the PBX, network and country of installation. For example, UK and Australia use 100, New Zealand uses 600. If you are unsure as to the correct setting for your installation initially select 1 = 100ms 1. The system setting switch must be in the position ON, see page 9. 2. Lift the handset (ignore any network announcements) and press z and *. 3. Press 0. 4. Select the required setting (1=100, 2=300, 3=600 ms). 5. Press z and replace the handset. Pause Time Duration This allows you to select the Pause timing. The time selected will depend on the PBX and network through which your memory number is being dialled. If you are unsure as to the correct setting for your installation initially, select 1 = 2.0. 1. The system setting switch must be in the position ON, see page 9. 2. Lift the handset (ignore any network announcements) and press z and *. 3. Press 2. 4. Select preferred setting (1=2.0 and 2=3.6 s). 5. Press z and replace the handset. English www.doro.com 11 Other Direct Dialling Waiting Time When direct dialling the period of time the telephone waits before dialling can be adjusted between 2.0-3.1 seconds. 1. The system setting switch must be in the position ON, see page 9. 2. Lift the handset (ignore any network announcements) and press z and *. 3. Pres...