Notice EPSON TM-H5000II

Notice EPSON TM-H5000II disponible gratuitement après inscription

Accédez à la notice du EPSON TM-H5000II en adhérant à la communauté.

Notice d’utilisation de votre EPSON TM-H5000II. La notice vous renseigne sur l’utilisation, donne des solutions aux problèmes d’entretien, de fonctionnement et d’assistance pour votre TM-H5000II.

Notices - manuels - modes d'emploi disponibles pour EPSON TM-H5000II après inscription au groupe d'entraide

Aperçu de la notice

Extrait de la notice

e of the inlet as a guide, as far as the check will go. See illustration 7. 3.The printer starts drawing the check in. Let go of the check immediately. The SLIP LED goes from flashing to on. 4.When MICR reading is complete, the printer ejects the check and the SLIP LED starts flashing again. 5.Remove the check by pulling it straight out (not at an angle). The SLIP LED goes off. Cleaning the Roll Paper Print Head CAUTION: After printing, the print head can be very hot. Be careful not to touch it and to let it cool before you clean it. Do not damage the print head by touching it with your fingers or any hard object. Turn off the printer, open the roll paper cover, and clean the thermal elements of the print head with a cotton swab moistened with an alcohol solvent (ethanol or IPA). Epson recommends cleaning the thermal head periodically (generally every 3 months) to maintain receipt print quality. Cleaning the Optional MICR Mechanism Clean the MICR head and MICR roller every 6000 passes or once a month. Note: If you encounter frequent MICR reading errors, use one of the following methods.10 TM-H5000II User’s Manual English For the MICR head Use a moistened cleaning sheet, such as PRESAT brand (KIC) “Check Reader Cleaning Card” or an equivalent commercially available cleaning sheet. For the MICR feed roller Use an adhesive cleaning sheet available from Epson. Contact your dealer. Cleaning procedure Use this procedure for both cleaning sheets. 1.Load the roll paper into the printer; then turn off the power. 2.Open the front cover and turn the power back on while holding down the RELEASE button. 3.Press the RELEASE button 7 times. 4.Close the front cover (the SLIP LED flashes). 5.Follow the instructions on the...

En cours...