Notice FOCAL Solution 25 A1 disponible gratuitement après inscription

Extrait de la notice

ould I use? Length Amperage0 - 1m1 - 1.5m1.5 - 2.3m2.3 - 3m3 - 3.8m3.8 - 6.1m6.1 - 7.6m7.6 - 9.5m9.5 - 13.3m13.3 - 19m 30A2.5mm24mm26mm28mm210mm216mm220mm225mm235mm250mm2 13AWG*11AWG*9AWG*8AWG*7AWG*5AWG*4AWG*3AWG*2AWG*0AWG* AWG : American Wire Gauge Route the low-level audio cables (RCA), the loudspeaker cables, the REMOTE cable, and the REMOTE CONTROL cable together and insulate them from other high-power car accessories, and in particular insulate them from electric motors (i.e. the windscreen-wiper motor, etc.). Retain the full length of the cables – adjustments can be made later. Route the positive power cables (+). Make sure when doing so to route them opposite the cables that you have previously drawn – this is to avoid any interference. DO NOT CONNECT THE CABLE YET. Get hold of the negative power cable. This cable should be as short as possible and ideally should not be any longer than 1 metre, to ensure effective coupling between the amplifier and the car’s chassis. The cable and its wire gauge should comply with the table on page 7. Find a suitable ground point (see fig. 9), then sand it to remove any traces of paint or other covering and in so doing optimise the contact point. Pierce the metal that you have previously sanded, making a hole the same size as the screw you are using, making sure that there are no tank cables or any other sensitive vehicle devices nearby. Remove the plastic around 1 cm of cable (see fig. 8) and then tin it. Screw the cable firmly down onto the amplifier’s GND terminal. Tin the other end of it and then crimp or weld it onto the terminal lug provided. Insert the terminal lug in the screw, and then put the screw and nut in place and screw-drive the screw in firmly. ACCESS SOLUTION 25 A1 User Manual...