Notice GEONAV 4C disponible gratuitement après inscription

Extrait de la notice

plorer not to erase the content of the \NAVIONIC and \GEONAV folders. Damaging the files stored in such directories may result in loss of data or improper operation of the unit. Cartridge Installation The full charge cycle of a battery set totally discharged re- quires at least two hours, depending on the battery type and status. Connections of power supply and data cable Power supply 1+VDC 2GND Data input ext. GPS 3ext. GPS in + 4ext. GPS in - Data output 5Autopilot out + 6Autopilot out - Audio output 7Audio out + 8Audio out - USB 9USB D + 10USB D - If sent by the autopilot, the following NMEA messages are transmitted to external devices: GGA - RMC - ZDA The GEONAV will add the following messages: APA - APB - XTE - RMB - BWC - GLL - VTG The data cable is optional. WARNING: Once the installation is completed, always make sure that all wires are properly connected since wrong connections may damage the unit. USB cable The GEONAV can be connected to a Personal Computer by using the optional USB cable. In this case, the unit can use the internal batteries only, and cannot be powered by the ex- ternal power. Connections16 17 EnglishEnglish Diagnostic DIAGNOSTIC The GEONAV features a diagnostic program to verify its cor- rect performance, once installed, and detect problems that may occur during the use of the unit. To access the diagnostic program, hold the ENTER key pressed, while pressing the PWR key. The GEONAV will switch on and execute automatically the diagnostic program. After displaying the system’s software releases, it will start carrying out the memory test. As soon as the memory test is completed, the program will test the NMEA 0183 port, the CompactFlash™, the external GPS device, the keyboard, the backlight, th...