Notice ION Audio LP 2 CD disponible gratuitement après inscription

Extrait de la notice

way from resting position (arm clip) for the turntable motor to activate. PLATTER SETUP WARNING: Incorrect Platter setup can lead to poor turntable performance, platter instability or permanent motor damage. 1. Start by placing the rubber drive belt around the inner bottom ring of the turntable platter. This should come preinstalled, but check to make sure that it is not twisted or damaged. 2. Install the platter on the center spindle and press it down firmly. Check to make sure that it rotates uniformly and does not wobble excessively. 3. Rotate the platter so that the one of the holes is aligned with the Start Stop button on the front corner of the turntable. The brass motor spindle should be visible through this hole. 4. Reach into the hole and pull the rubber drive belt off of the inner ring, and install it over the motor spindle. Be careful not to twist the rubber drive belt during this step. Check to make sure the platter rotates uniformly. If the drive belt is properly installed, there should be a slight amount of tension that brings the platter to a stop after spinning it freely. 6 MOUNTING THE DUST COVER 1. Attach the included dust cover mounts to the turntable. 2. Attach the dust cover to the mounts as shown in illustration on the left. THE TWO MODES The LP 2 CD features two general modes of operation: CD Player Mode and Internal Flash Player Mode. The currently selected Mode will be indicated by the two LEDs (CD and INT) located to the right of the display, as shown here. CD Player Mode allows you to: Play music from non-blank CDs using standard transport controls (Play, Pause, Stop, Skip, Fast- Forward and Rewind) Copy a specific CD track to the Internal Flash Player...