Notice MSI PM8M-V

Manuel MSI PM8M-V disponible gratuitement après inscription

Le groupe d'entraide MSI PM8M-V est ravi de partager cette notice avec vous

Notice d’utilisation de votre MSI PM8M-V. La notice vous renseigne sur l’utilisation, donne des solutions aux problèmes d’entretien, de fonctionnement et d’assistance pour votre PM8M-V.

Notices - manuels - modes d'emploi disponibles pour MSI PM8M-V après inscription au groupe d'entraide

Aperçu de la notice

Extrait de la notice

will automatically close. 7 3 4 1 2 GND12V GND12V Memory Speed/CPU FSB Support Matrix Memory FSB DDR333 DDR 400 133 MHz YES YES 166 MHz YES YES 200MHz YES YES For the updated supporting memory modules, please visit our Web site at http://www.msi.com.tw/program/products/mainboard/mbd/pro_mbd_trp_list.php Power Supply The mainboard supports ATX power supply for the power system. Before inserting the power supply connector, always make sure that all components are installed properly to ensure that no damage will be caused. Power supplies of 300watt (and up) are highly recommended for system stability. ATX 20-Pin Power Connector: ATX1 This connector allows you to connect to an ATX power supply. To connect to the ATX power supply, make sure the plug of the power supply is inserted in the proper orientation and the pins are aligned. Then push down the power supply firmly into the connector. ATX 12V Power Connector: JPW1 This 12V power connector is used to provide power to the CPU. Floppy Disk Drive Connector: FDD1 The mainboard provides a standard floppy disk drive connector that supports 360K, 720K, 1.2M, 1.44M and 2.88M floppy disk types. 3.3V -12V GND GND PW_OK-5V 5V_SB5V 12V PS_ON 1020 111 GND GND 5V GND GND GND 5V 5V 3.3V 3.3V 8 ControlControl SENSOR +12V GND IDE Connectors: IDE1 & IDE2 The mainboard has a 32-bit Enhanced PCI IDE and Ultra DMA 33/66/100/133 controller that provides PIO mode 0~4, Bus Master, and Ultra DMA 33/66/100/133 function. You can connect up to four hard disk drives, CD-ROM, 120MB Floppy and other devices. The first hard drive should always be connected to IDE1. IDE1 can connect a Master and a Slave drive. You must configure se...

En cours...