Notice NAD C350

Notice NAD C350 disponible gratuitement après inscription

Accédez à la notice du NAD C350 en adhérant à la communauté.

Notice d’utilisation de votre NAD C350. La notice vous renseigne sur l’utilisation, donne des solutions aux problèmes d’entretien, de fonctionnement et d’assistance pour votre C350.

Notices - manuels - modes d'emploi disponibles pour NAD C350 après inscription au groupe d'entraide

Aperçu de la notice

Extrait de la notice

C350 to external processor or pre- amplifier first remove these links. Use a twin RCA-to-RCA lead to connect to the left and right ‘Audio Output’ of the pre-amp or processor to the Main-In sockets. NOTE:always turn the amplifier off before connecting or disconnecting anything to the Pre-Out and Main-In sockets. 12. SPEAKERS Speaker terminals for speakers with an impedance of 4 ohms or more. Connect the right speaker to the terminals market ‘R +’ and ‘R-’ ensuring that the ‘R+’ is connected to the ‘+’ terminal on your loudspeaker and the ‘R-’ is connected to the loudspeaker’s ‘- ’ terminal. Connect the terminals marked ‘L+’ and ‘L-’ to the left speaker in the same way. Always use heavy duty (16 gauge; 1.5mm, or thicker) stranded wire to connect loudspeakers to your NAD C350. The high-current binding post terminals can be used as a screw terminal for cables terminating in spade or pin sockets or for cables with bare wire ends. BARE WIRES AND PIN CONNECTORS Bare wires and pin sockets should be inserted into the hole in the shaft of the terminal. Unscrew the speaker terminal’s plastic bushing until the hole in the screw shaft is revealed. Insert the pin or bare cable end into the hole and secure the cable by tightening down the terminal’s bushing. Ensure bare wire from the speaker cables does not touch the back panel or another socket. Ensure that there is only 1/2” (1cm) of bare cable or pin and no loose strands of speakers wire. 13. SOFT CLIPPING When an amplifier is driven beyond its specified power output, a hard, distorted sound can be heard on very loud sounds. This is caused by the amplifier cutting off or ‘hard clipping’ the peaks of sound that it was not designed to reproduce. The NAD Soft Clipping circuit gently limits the output of...

En cours...