Notice NAD C422 disponible gratuitement après inscription

Extrait de la notice

On by ancillary equipment such as an amplifier or preamp, AV processor, etc. which are also equipped with a 12V trigger output. For switching Stand-by/Power On of the C 422 by an external component, connect the12V-trigger input of the C 422 to the remote component’s DC output jack. The plug required is a standard 3.5mm Mini-Jack plug ("mono"): The tip is the live or + connection, the shaft of the input jack is the 12V-trigger – or ground connection. NOTE The C 422’s 12V Trigger will work within a range of 6 to 15 V DC level and typically draws less than 10mA of current. Check the specifications of the Trigger output terminal on the remote component to ensure it is compatible with the C 422’s 12Vtrigger input. NAD components equipped with 12V output triggers are fully compatible with the C 422’s 12V input trigger. Before making any connections to any 12V trigger input or output, make sure all components are disconnected from the AC mains. Failure to observe the above may result in damage to the C 422 or any ancillary components attached to it. If in doubt over the connections, installation and operation of the 12V trigger output consult your NAD dealer. 6AC Line cord -Plug the AC power cord into a live AC wall socket or to an AC convenience outlet at the rear of your amplifier. C422 manual - 6 8/8/03 5:32 PM Page 56 ENGLISHFRANÇAIS DEUTSCH NEDERLANDS ESPAÑOL ITALIANO PORTUGUÊS SVENSKA FRONT PANEL CONTROLS 1Power On/Off - POWER switches the tuner on or off. Pressing the Power switch turns the Tuner on, the Display Panel and Power Status Indicator (No. 2) will light up. Pressing the Power button again will switch the unit off. NOTE The C 422 has a receiver for remote control commands built-in. Most NAD system remote control handsets...