rature dial to a position between 2and MAX and squeeze the steam trigger for about 1 minute. Fill the water tank (see chapter 'Preparing for use').Set the temperature dial to a position between 2and MAX and squeeze the steam trigger for about 1 minute. Select an ironing temperature that is suitable for steam ironing (2to MAX).Wait until the amber pilot light has gone out before you start ironing. Fill the water tank (see chapter 'Preparing for use').Set the temperature dial to a position between 2and MAX and squeeze the steam trigger for about 1 minute. Select an ironing temperature that is suitable for steam ironing (2to MAX).Wait until the amber pilot light has gone out before you start ironing. Rinse the water tank and do not put any additive in the water tank. Use the calc-clean function a few times (see chapter 'Cleaning and maintenance'). Possible cause(s) There is a connection problem. The temperature dial has been set to MIN. The water level is too low,the anti- calc cassette has not been properly inserted and/or the temperature has been set to a position below 2. There is not enough water in the water tank or in the internal reservoir. There is not enough water in the water tank or in the internal reservoir. The iron is not hot enough and/or the drip-stop function has been activated. There is not enough water in the water tank or in the internal reservoir. The iron is not hot enough. An additive has been poured into the water tank. Hard water forms flakes inside the soleplate. Problem The iron is plugged in but the soleplate is cold. The iron does not produce steam and the water tank produces a loud noise. No spray. No steam. No shot of steam or no vertical shot of steam. Water droplets drip onto the fabr...