AIN COMPONENTS 1Cover of the water fill opening2Water fill opening3ON-OFF indicator light4Steamer5Removable tray6OFF/COFFEE/STEAM selector control7Dispenser spoon8Filter with dose indicator for 2/4 cups9Filter holder10Filter holder flap11Coffee outlet hole12Jug lid13Measuring jug for up to 4 cups14Filter holder support15Power cord 2USE ZThis appliance has been designed for coffee extraction and for heating milk and other liquids (water, broth, chocolate) using hotsteam.ZBefore using the machine with coffee for the first time, we recommend you allow 4-8 cups of water to run through the filterholder. This will fully clean the entire system. 1Place the appliance on a flat and stable surface. COFFEE PREPARATION 1Fill the water tank. To do so: unscrew the cover (1) by turning itanti-clockwise.2Using the jug (13), pour the required amount of water for two or fourcups into the fill opening (2).3Screw the cover (1) back on to seal the tank.4Plug the coffee maker into the mains using the power cord (15).5Place the filter (8) in the filter housing (9).6Use the dispenser spoon (7) to fill the filter (8) up to the markcorresponding to the desired cups of coffee (two or four), withoutpressing the coffee too much.7Lift the flap (10) and insert the filter holder (9) in the filter holdersupport (14), pressing upwards (fig. 1). Simultaneously turn it to theright until it is locked in position (fig. 2).8Place the jug (13) on the tray (5) and align the cover opening (12)with the coffee outlet hole (11).9Move the OFF/COFFEE/STEAM selector (6) to the COFFEEposition (fig. 3).iThe red indicator light (3) will come on, indicating that the coffeemaker is in operation. Coffee will start to come out.10If you want to increase the coffee flow rate, turn the selector control(6) to its fully op...