Notice SONY MDR-RF865RK

Notice SONY MDR-RF865RK disponible gratuitement après inscription

Accédez à la notice du SONY MDR-RF865RK en adhérant à la communauté.

Notice d’utilisation de votre SONY MDR-RF865RK. La notice vous renseigne sur l’utilisation, donne des solutions aux problèmes d’entretien, de fonctionnement et d’assistance pour votre MDR-RF865RK.

Notices - manuels - modes d'emploi disponibles pour SONY MDR-RF865RK après inscription au groupe d'entraide

Aperçu de la notice

Extrait de la notice

a moderate level with the VOL control on the right housing. Turn the VOL control towards the dot to turn up the volume. Tactile dot Notes ? When watching films, be careful not to raise the volume too high in quiet scenes. You may hurt your ears when a loud scene is played. ? This equipment is guaranteed for use in the temperature range of 5°C to 35°C (41°F to 95°F). ? You may hear some noise when you disconnect the AC power adaptor from the transmitter before removing the headphones. After use Turn off the power of the headphones. Note Note that battery capacity may decrease if the headphones are turned on and placed on the transmitter with the AC power adaptor disconnected from the transmitter. Sending RF signals from the transmitter The transmitter starts sending RF signals automatically when it detects an audio signal from the connected equipment. Notes ? Any noise you hear through the headphones may vary depending on the transmitter position and room conditions. It is recommended that you place the transmitter in a location that produces the clearest sound. ? If the transmitter is placed on a metallic table, you may hear noise, or the reception range may decrease. Do not place the transmitter on a metallic table. If an audio signal is not input for about 5 minutes RF signal transmission from the transmitter automatically stops when an audio signal is not input for about 5 minutes. When the transmitter stops, the transmitter’s POWER indicator blinks in green for 60 seconds and then turns off. The RF signals are automatically transmitted when an audio signal is input again. RF signal transmission may stop when an extremely low sound is input for about 5 minutes. If this happens, raise the volume of the co...

En cours...