f insulation. After connecting all the components, speakers, and AC power cord, output a test tone to check that all the speakers are connected correctly. For details on outputting a test tone, refer to “Adjusting the speaker volume” on page 10. If you have connected rear speakers, be sure to press the 5.1 CH/DVD button and turn off sound field on the receiver before outputting a test tone so that the tone is output individually from the left and right rear speakers. If no sound is heard from a speaker while outputting a test tone or a test tone is output from a speaker other than the one whose name is currently displayed on the receiver, the speakers may be short-circuited. If this happens, check the speaker connection again. WOOFER AUDIO OUT INPUT – REAR RRL +9GB Getting Started AC Hookups Connecting the mains lead Connect the mains lead from this receiver and from your audio/video components to a wall outlet. If you connect other audio components to the SWITCHED AC OUTLET on the receiver, the receiver can supply power to the connected components so you can turn on/off the whole system when you turn on/ off the receiver. Caution Make sure that the power consumption of the component connected to the receiver’s AC outlet does not exceed 100 watts. Do not connect high-wattage electrical home appliances such as electric irons, fans, or TVs to this outlet. Where do I go next? Before you use thereceiver, go to the next section to make sure that all the controls are set to the appropriate positions. to a wall outlet / SWITCHED AC OUTLET Before You Use Your Receiver Before turning on the receiver Make sure that you have: •Turned MASTER VOLUME to the leftmost position (0). •Selected the appropriate front speakers (see “Front...