Notice SONY VPL-HS10 disponible gratuitement après inscription

Extrait de la notice

sion Lens with the thread around the lens of the projector as illustrated below. 4Turn the Conversion Lens clockwise until you hear it click. Note If the Conversion Lens is hard to turn, turn it slightly counterclockwise first, then turn it clockwise. 5Place a thick cloth (e.g., a cushion) beneath the projector. Place the projector face down. Notes •You cannot install the Conversion Lens on the projector’s lens with the Cinema Filter attached. Remove the Cinema Filter when you install the Conversion Lens. •The optional Conversion Lens projects from the top of the projector when the Lens is installed on the projector. Before installation, place a cloth of adequate thickness beneath the projector to keep the Lens from contact with the floor or a desk top. Otherwise, the Lens may malfunction if it receives too much pressure from the weight of the projector. 6Fasten the end of the safety wire of the Conversion Lens to the bottom of the projector using the screw supplied with the Conversion Lens (M5×8, with washer). Note Be sure to fasten the end of the safety wire of the Lens to the bottom of the projector. When installing the projector on the ceiling Be sure to fasten the end of the safety wire of the Lens to both the projector and the PSS-610 Projector Suspension Support in step 6, as illustrated below. In this case, use the screw (M5×12, with washer) supplied with the PSS-610. First, place the PSS-610 ( 1 ) on the projector, then place the safety wire ( 2 ) on the PSS-610. WARNING Be sure to use the screw (M5×12 with washer) supplied with the PSS-610. Never use the screw supplied with the Conversion Lens. If you use the screw supplied with the Lens, the Lens may fall from the projector and may cause injur...