dress automatically.7 1. Go into the Control Panel, click Network and Internet, click Network and Sharing Center, click Manage Network Connections and then right-click the Local Area Connection icon and then click Properties. Windows Vista 2. Click Internet Protocol Version 4(TCP/IPv4) and then click Properties. Then click on Obtain an IP address automatically. 1. Go into the Control Panel, double-click the Network Connections icon and then right-click the Local Area Connection icon and then click Properties. Windows XP/2000 2. Click Internet Protocol (TCP/IP) and then click Properties. Then click on Obtain an IP address automatically. 4. I have a HomePlug 1.0 or HomePlug Turbo network. Can I use this with my network? The TPL-402E is not backwards compatible with HomePlug 1.0 or HomePlug Turbo. 5.Do I need to reconfigure my TPL-402E after I hit the reset button? No, the TPL-402E should automatically establish connection once both units are reset to default settings. If you still encounter problems or have any questions regarding the TPL-402E/TPL-402E2K, please refer to the User's Guide included on the Utility CD-ROM or contact TRENDnet's Technical Support Department.Description of Modes Erp (EuP) Operation: Standby Mode The EUT has no external mechanical switch and uses an internal program to control active and standby modes. Disconnect the Ethernet cables from the device Ethernet ports, and after 3 minutes, the device will enter standby mode. The Power (PWR) LED will flash every 15 seconds to indicate that the device is currently in standby mode. To return to active mode, reconnect the Ethernet cables to the device Ethernet ports, and the device will re-enter active mode. Copyright ©2011. All Rights Reserved. TRENDnet....