olume control This control allows you to balance the output from the subwoofer to the main speakers in your system. This control should be set to achieve similar volume level from both the main speakers and subwoofer. Low-pass crossover Both sets of inputs sum the left and right channels together and the resulting signal is passed through an adjustable low-pass crossover before being amplified. The crossover control allows you to adjust the upper limit of the subwoofer's frequency response from 40 to 120 Hz. The subwoofer's response will begin rolling off above the frequency you set this control to. You should set the crossover frequency to obtain a smooth and seamless transition from the subwoofer to the main speakers in your system. If your main speakers are smaller units with limited low frequency output, you may wish to choose a higher frequency (such as 100-120Hz) than you would with larger speakers which have greater low frequency output. With larger speakers, you might start with this control set lower, such as 80Hz. 3 3 InstallationVous avez le choix entre de nombreuses options pour installer votre enceinte d’extrêmes graves. Veuillez lire les recommendations ci-dessous pour déterminer quelle option est préférable pour votre système. Attention: toutes les procédures d’installation doivent être ef fectuées hors tension, votre enceinte étant débranchée ou arrétée. Entrées Votre nouvelle enceinte est équipée avec les deux entrées niveau haut-parleur et niveau ligne. Utiliser les prises RCA/Phono " INPUT " si vous connectez votre enceinte à un pré-amplificateur , un processeur à signaux, ou bien à une coupure niveau ligne. Les prises de l’amplificateur " SPEAKER LEVEL-INPUT " se connectent directement aux sorties du...