Notice YAMAHA DSP-E492

Notice YAMAHA DSP-E492 disponible gratuitement après inscription

Accédez à la notice du YAMAHA DSP-E492 en adhérant à la communauté.

Notice d’utilisation de votre YAMAHA DSP-E492. La notice vous renseigne sur l’utilisation, donne des solutions aux problèmes d’entretien, de fonctionnement et d’assistance pour votre DSP-E492.

Notices - manuels - modes d'emploi disponibles pour YAMAHA DSP-E492 après inscription au groupe d'entraide

Aperçu de la notice

Extrait de la notice

el Power Amplifier Center:60W (8?) RMS Output Power, 0.04% THD, 20 – 20.000 Hz Rear:60W + 60W(8?)RMS Output Power, 0.04% THD, 20 – 20.000 Hz lDigital Sound Field Processor lDolby Pro Logic Surround Decoder lTheater-like Sound Experience by the Combination of Dolby Pro Logic and YAMAHA DSP Technology (CINEMA DSP) lAutomatic Input Balance Control for Dolby Pro Logic Surround lTest Tone Generator for Easier Speaker Balance Adjustment l3 Center Channel Modes (NORMAL/WIDE/PHANTOM) lVideo Signal Input/Output Capability l6-Channel Discrete Input Terminals for Connecting with a Dolby Digital (AC-3) Decoder l6-Channel Input Terminals to Input Audio Signals from Your Existing Amplifier or Receiver lRemote Control Capability FEATURES Battery installation Battery replacement If you find that the remote control transmitter must be used closer to the main unit, the batteries are weak. Replace both batteries with new ones. Notes lUse only AA, R6, UM-3 batteries for replacement. lBe sure the polarities are correct. (See the illustration inside the battery compartment.) lRemove the batteries if the remote control transmitter will not be used for an extended period of time. lIf batteries leak, dispose of them immediately. Avoid touching the leaked material or letting it come in contact with clothing, etc. Clean the battery compartment thoroughly before installing new batteries. Remote control transmitter operation range Notes lThere should be no large obstacles between the remote control transmitter and the main unit. lIf the remote control sensor is directly illuminated by strong lighting (especially an inverter type of fluorescent lamp etc.), it might cause the remote control transmitter not to work correctly. In this case, reposit...

En cours...