Notice LINKSYS SD208

« or a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used according to the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which is found by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna • Increase the separation between the equipment or devices • Connect the equipment to an outlet other than the receiver’s • Consult a dealer or an experienced radio/TV technician for assistance EC Declaration of Conformity (Europe) In compliance with the EMC Directive 89/336/EEC, Low Voltage Directive 73/23/EEC, and Amendment Directive 93/68/EEC, this product meets the requirements of the following standards: • EN55022 Emission • EN55024 Immunity SD205_SD208_SD216-EU-UG-30606NC JL 25 Chapter 2:Getting to Know the 10/100 Switch Planning Your Network Layout The 5-, 8-, and 16-Port 10/100 Switches differ in number of LEDs and ports. Pictured here is the 5-Port 10/100 Switch; however, the other Switches are similar in form. SystemGreen. The System LED will light up when the Switch is powered on. 1-5, 1-8, or 1-16Green. Each LED will light up when there is a connection made through its corresponding port. It will flash when there is activity on its corresponding port. The network ports are located on the back panel of the Switch. 1-5, 1-8, or 1-16These ports are connection points for PCs and other network devices, such as additional switches. Overview Front Panel LEDs Back and Side Panel Features 4 Chapter 1:Introduction r This newly redesigned Linksys 5-, 8-, or 16-Port 10/100 Switch can significantly increase your network traffic’s speed. A switch serves the same function as a hub in a network design—tying your network equipment together. But unlike a simple-minded hub which divides the network’s bandwidth among all the attached devices, a switch delivers full network speeds at each port. Installing this cost-effective 5-, 8-, or 16-Port 10/100 Switch can potentially increase your network speed by five, eight, or sixteen times! It's the perfect way of integrating 10Mbps Ethernet and 100Mbps Fast Ethernet devices, too. All ports are auto speed negotiating, and have automatic MDI/MDI-X crossover detection, so you don’t have to worry about the cable type. Each port independently negotiates for best speed and half- or full-duplex mode, for up to 200Mbps of bandwidth per port. Fast store-and-forward switching prevents damaged packets from being passed on into the network. The new, ultra-compact case design is sure to fit into your workgroup environment. Let the Linksys 5-, 8-, or 16-Port 10/100 Switch kick your 10/100 network into high gear. •Ideal for Integrating Your 10BaseT and 100BaseTXNetwork Hardware •5, 8, or 16 10/100 Ports Provide Dedicated Bandwidth in Half- or Full- Duplex Modes •Each Port Supports Auto MDI/MDI-X Cable Detection •Compatible with All Major Network Operating Systems •Advanced Store-and-Forward Packet Switching Optimizes... »