Notice ZYXEL G-570S

« WER port and connect the power adaptor to a power supply (outlet). Installation Verification When the power and the ETHERNET port are properly connected, the PWR blinks while performing system tests and then turns steady on. The ETHN and the WLAN LEDs also turn on. See the Front Panel LED Description table in the User's Guide for more information. Default Settings Use a wireless-ready computer to search for and join the wireless network to access the Internet. The default settings of the G-570S are shown below: SSID: ZyXEL G-570S Channel: 6 Security: Disable Security is disabled by default. This means your neighbor could access and see your network traffic. See the User's Guide for how to enable wireless security. Introduction to OTIST In a wireless network, the wireless clients must have the same SSID and security settings as the access point (AP) or wireless router (we will refer to both as "AP" here) in order to associate with it. Traditionally this meant that you had to configure the settings on the AP and then manually configure the exact same settings on each wireless client. OTIST (One-Touch Intelligent Security Technology) allows you to transfer your AP's SSID and WEP or WPA- PSK security settings to wireless clients that support OTIST and are within transmission range. You can also choose to have OTIST generate a WPA-PSK key for you if you didn't configure one manually. Enabling OTIST You must enable OTIST on both the AP and wireless client before you start transferring settings. We use the G-570S and the G-162 screens in this guide as an example. Screens may vary slightly for your ZyXEL devices. AP You can enable OTIST using the OTIST button or the web configurator. If you use the OTIST button, the default (01234567) or previous saved (through the web configurator) Setup key is used to encrypt the settings that you want to transfer. Hold in the OTIST button for one or two seconds. See the the User's Guide for how to use the web configurator to enable OTIST on the AP. Wireless Client Start the ZyXEL Utility and click the Adapter tab. Select the OTIST check box, enter the same Setup Key as your AP's and click Save. Starting OTIST 1In the AP, a web configurator screen pops up showing you the security settings to transfer. After reviewing the settings, click OK. 2This screen appears while OTIST settings are being transferred. It closes when the transfer is complete. •In the wireless client, you see this screen if it can't find an OTIST-enabled AP (with the same Setup key). Click OK to go back to the ZyXEL Utility main screen. •If there is more than one OTIST-enabled AP within range, you see a screen asking you to select one AP to get settings from. Notes on OTIST 1If you enabled OTIST in the wireless client, you see this screen each time you start the ZyXEL Utility. Click Yes for it to search for an OTIST-enabled AP. 2If an OTIST-enabled wireless client loses its wireless connection for more than ten seconds, it will search for an OTIST-enabled AP for up to one minute. (If you manually have the wireless client search for an OTIST-enabled AP, there is no timeout; click Cancel in the OTIST progress screen to stop the search.) 3When the wireless client finds an OTIST-enabled AP, you must still hold in the OTIST button (for one or two seconds) for the AP to transfer settings. 4If you change the SSID or the ke... »