Notice MERLIN GERIN Pulsar Evolution 2200

« the end of its service life. To discover the entire range of MGE UPS SYSTEMS products and the options available for the Pulsar Evolution range, we invite you to visit our web site at www.mgeups.com or contact your MGE UPS SYSTEMS representative.Page 4 - 34007115EN/AA Foreword Using this document Important instructions that must always be followed. Information, advice, help. Visual indication. Action. Audio indication. In the illustrations on the following pages, the symbols below are used: LED off. LED on. LED flashing. Information may be found in two ways, using: w the contents; w the index. Pictograms34007115EN/AA - Page 5 Contents 1.Presentation 1.1Overall view................................................................................................................................. 7 Tower position.................................................................................................................................7 Rack position..................................................................................................................................7 1.2Back............................................................................................................................................. 8 1.3Control panel.................................................................................................................................9 2.Installation 2.1Unpacking and parts check.......................................................................................................10 2.2Upright installation (tower position).........................................................................................11 2.3Flat installation (rack position)..................................................................................................12 2.4Connecting the protected equipment.......................................................................................13 2.5Connection to the RS232 or USB communications port (optional).........................................14 2.6Connection to the data-line protection port (optional).............................................................14 2.7Installation of the communications-card option......................................................................15 3.Operation 3.1Start-up........................................................................................................................................16 3.2Shift to booster or fader mode (during voltage variations in the AC-input power).....................16 3.3Operation on battery power (following failure of AC-input power).............................................17 Transfer to battery power..............................................................................................................17 Threshold for the low-battery warning...........................................................................................17 3.4Personalisation (optional)...........................................................................................................18 Function........................................................................................................................................18 ON / OFF conditions tab...............................................................................................................18 Battery tab.................................................................................... »