Notice DFI AD77 Infinity

« ity of such revisions or changes. © 2002. All Rights Reserved. Trademarks Microsoft® MS-DOS®, WindowsTM, Windows® 95, Windows® 98, Windows® 98 SE, Windows® ME, Windows® 2000, Windows NT® 4.0 and Windows® XP are registered trademarks of Microsoft Corporation. AMD, AthlonTM XP, AthlonTM and DuronTM are registered trademarks of Advanced Micro Devices, Inc. VIA is a registered trademark of VIA Technologies, Inc. Award is a registered trademark of Award Software, Inc. Other trademarks and registered trademarks of products appearing in this manual are the properties of their respective holders. Caution To avoid damage to the system: •Use the correct AC input voltage range..... To reduce the risk of electric shock: •Unplug the power cord before removing the system chassis cover for installation or servicing. After installation or servicing, cover the system chassis before plugging the power cord.Battery: •Danger of explosion if battery incorrectly replaced. •Replace only with the same or equivalent type recommend by the manufacturer. •Dispose of used batteries according to the battery manufacturer’s instructions. Joystick or MIDI port: •Do not use any joystick or MIDI device that requires more than 10A current at 5V DC. There is a risk of fire for devices that exceed this limit. FCC and DOC Statement on Class B This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: •Reorient or relocate the receiving antenna. •Increase the separation between the equipment and the receiver. •Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. •Consult the dealer or an experienced radio TV technician for help. Notice: 1.The changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. 2.Shielded interface cables must be used in order to comply with the emission limits.4 Quick Setup Guide1 Quick Setup Guide Notice This user’s manual contains detailed information about the system board. If, in some cases, some information doesn’t match those shown in the multilingual manual, the multilingual manual should always be regarded as the most updated version. The multilingual manual is included in the system board package. To view the user’s manual, insert the CD into a CD-ROM drive. The autorun screen (Main Board Utility CD) will appear. Click “User’s Manual”. System Board This user’s manual is for the AD77 INFINITY and AD77 Pro system boards. The differences between these boards are shown below. Three IEEE 1394a connectors One Serial ATA connector One RAID IDE connector RJ45 LAN port ! ! ! ! AD... »