Notice BROAN HI7356VI

« th an outside motor (Fig. 3), a vacuum suction unit must be connected; this exhaust will operate separately, conveying the exhaust air through the unit. Only use vacuum units suggested in the original catalogue. INSTALLATION ATTENTION: Two persons are required for proper installation; the unit should be installed by a qualified operator. Also follow carefully each step of the assembly instructions, and once installation has been completed, make sure that the hood is firmly secured in place. To facilitate installation, before starting remove the grease filters: press inward on the clamp at the handle and pull the filter downward (Fig. 4). For assembling it is essential to: – Prepare the connection to the mains within the telescopic flue. – If your unit is installed in an ducting hood or in a hood with outside motor, prepare the air exhaust hole. When installing ducting hoods and hoods with outside motor, to achieve the best possible conditions use an air exhaust pipe that : is as short as possible, has a minimum of curves (maximum angle: 90°), is made of a material that complies with the standards (which vary from nation to nation) and iv) is smooth on the inside. It is also advisable to avoid any drastic changes in pipe section (diameter: 150 mm). ASSEMBLING - Using the special drilling template, drill the holes for fixing to the ceiling on the vertical side of your hob. Carefully observe all the indications for final positioning of the apparatus. Take into account that one of the template axes must correspond to the axis of the hood controls. Fix the bracket to the ceiling using the screws and screw anchors provided (Fig. 5). Be careful, because the position of the bracket determines the final position of the apparatus: the side with the slot B corresponds to the side opposite the commands. Mount the plate of the electrical system fixing it with 3 screws and 2 metal washers (Fig. 6). Ducting version and version with an external motor: Fix the telescopic structure to the bracket by means of 4 screws (provided), running the air evacuation pipe through the telescopic structure and the electric power cable through the special hole in the bracket (Fig. 7). Adjust the height of the telescopic structure by means of the four retaining screws C (Fig. 8), taking into account that the height of the hood is 86 mm and that the distance between the hood and the hob must be at least 650 mm (Fig. 9). Take the upper pipe (with the round slots) and fit it on the telescopic structure with the slots facing downwards; fit the pipe to the bracket with 2 screws (Fig. 10). Take the lower pipe and fit it in the same manner as before; slide it to the top and stop it in that position using a screw inserted in the hole of the upper pipe as a catch (Fig. 11). Fit the hood to the telescopic structure by means of 4 screws (provided) – Fig. 12. Fix the air evacuation pipe to flange through opening D (Fig. 12) by means of a metal ring (pipe and ring are not supplied). Only for models with outside motor (Fig. 13): plug the hood into the outside control unit using the special terminal block: remove wire clamp A and lid B from the wiring junction box; secure the wire connecting the control unit to terminal C; then replace wire clamp A and lid B on the wiring junction box; the other end of the wire is secured to the terminal block on the outside control unit. Make the electrical connection by means of the power cable. Remove the screw... »