Notice NAD 310

« accompanying the appliance Note to CATV system installer: This reminder is provided to call the CATV installer's attention to Article 820-40 of the NEC , which provides guidelines for proper grounding and, in particular, specifies that the cable should be connected to the grounding system of the building, as close to the point of cable entry as practical. NAD 2 NAD 310 STEREO INTEGRATED AMPLIFIER CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN ATTENTION: RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER SEVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. AFIN DEVITER UN CHOC ELECTRIQUE, ET LES CONSEQUENCES GRAVES QUI POURRAIENT EN RESULTER, TENTEZ PAS D'OUVRIR L'APPAREIL ET DE TOUCHER AUX COMPOSANTS INTERNES SANS LA PRESENCE D'UNE SERVICE PERSONNEL.NAD 3 FRONT PANEL CONTROLS FIGURE 1. FIGURE 2. PLAY TAPE REC R L R L INPUT TAPE OUTPUTINSTRUCTIONS FOR INSTALLATION AND OPERATION A NOTE ON INSTALLATION This unit may be installed on any stable surface. Since its power transformer (near the left-rear corner) generates a magnetic hum field of moderate strength, an LP turntable should not be located directly to its left. The amplifier also generates a modest amount of heat and thus requires some ventilation. Do not place it on a rug or other soft surface that it could sink into, obstructing the air inlets on its bottom. And do not allow papers or cloth to obstruct the ventilation grille in the top cover. CAUTION:To prevent a fire or shock hazard, do not permit this product to become wet. If liquid is accidentally spilled on it, immediately shut off its power and unplug the AC power cord. Allow suffi- cient time for complete evaporation to occur before operating the amplifier again. If the liquid is anything but water and/or alcohol, the amplifier should be examined by a service technician before power is applied to it. Do not remove the cover, or attempt to modify or repair the amplifier yourself. Refer all servicing to a qualified technician. REAR PANEL CONNECTIONS 1. AC LINE CORD After you have completed all connections to the amplifier, plug the AC line cord into a “live” wall sock- et or into a heavy-duty extension cord. WARNING TO UK USERS. If this appartus is not fitted with a UK three-pin plug, do not attempt to insert the attached plug into a UK mains socket. Instead, cut the plug from the mains lead and attach a fusedUK three-pin plug using the following safety advice on wiring. IMPORTANT.The wires in this mains lead are coloured BLUEand BROWN; BLUE: NEUTRAL BROWN: LIVE The colours of these mains lead wires may not corre- spond with the coloured markings identifying the ter- minals in your plug. In this case the BROWNwire must be connected to the terminal which is marked L(ive) or coloured RED. The BLUEwire must be con- nected to the terminal marked N(eutral) or coloured BLACK.No connection should be made to the termi- nal marked E or coloured green or green and yellow 2. SPEAKER TERMINALS. Use these high-current binding-post terminals to connect your main stereo speakers. Each binding post consists of a threaded metal shaft and a red or black plastic screw-on bushing. Connect the wires from your left-channel speaker to the (L+) and (L-) terminals, and connect the wires from the right-channel speaker to... »