Notice PHILIPS FR984

« plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. If the mains plug contains a fuse, this should have a value of 5 Amp. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 5 Amp. Note:The severed plug must be disposed of to avoid a possible shock hazard should it be inserted into a 13Amp socket elsewhere. How to connect a plug The wires in the mains lead are coloured with the following code: blue = neutral (N), brown = live (L). As these colours may not correspond with the colour markings identifying the terminals in your plug, proceed as follows: •Connect the blue wire to the terminal marked N or coloured black. •Connect the brown wire to the terminal marked L or coloured red. •Do not connect either wire to the earth terminal in the plug,marked E (ore) or coloured green (or green and yellow). Before replacing the plug cover, make certain that the cord grip is clamped over the sheath of the lead - not simply over the two wires. Copyright in the U.K. Recording and playback of material may require consent. See Copyright Act 1956 and The Performer’s Protection Acts 1958 to 1972.3 English....................................................4 Français.................................................26 Español.................................................48 Deutsch.................................................70 Nederlands...........................................92 EnglishFrançaisEspañolDeutschNederlands ItalianoItaliano................................................114GENERAL INFORMATION 4 This receiver is supplied including: – a remote control – 2 batteries for the remote control, size AA – a coaxial cable for audio connection with a DVD player – a system bus cable for the CINEMA LINK connection – a loop antenna – a wire antenna – this instruction booklet If you have stacked the components of your system, the receiver must be on top. Place the receiver on a flat, hard, stabile surface. Do not cover any vents and leave 50 cm above and 10 cm left and right of the receiver free for ventilation. For good reception the loop antenna should not be placed on top of or beneath VCRs, CD recorders, DVD players, TVs and other radiation sources. All redundant packing material has been omitted. We have done our utmost to make the packaging easily separable into three mono materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet). Your set consists of materials which can be recycled if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packing materials, exhausted batteries and old equipment. Manufactured under license from Dolby Laboratories. “DOLBY”, “DOLBYDIGITAL”,“PRO LOGIC” and the double-D symbol 2are trademarks of Dolby Laboratories. Confidential unpublished works. © 1992–1997 Dolby Laboratories. All rights reserved. “DTS” and “DTS Digital Surround” are trademarks of Digital Theater Systems, Inc. Copyright 1996 Theater Systems, Inc. All Rights Reserved. Clean the receiver with a soft, slightly dampened, lint-free cloth. Do not use any cleaning agents as they may have a corrosive effect. Do not expose the receiver to humidity, rain, sand or excessive heat (caused by heating equipment or direct sunlight). Maintenance Trademark acknowledgment Environmental informati... »