Notice SONY STR DE375B

« e the sound Press BASS BOOST to turn on the BASS BOOST indicator. Turn the BALANCE control left or right. Adjust the BASS and TREBLE controls. To Mute the sound Reinforce the bass Adjust the balance Adjust the tone quality When you listen with headphones Connect the headphones to the PHONES jack and set the SPEAKERS buttons to OFF. To turn off the components Press POWER. You can turn off the video and audio components connected to the SWITCHED AC OUTLET at the same time.9EN Receiver Operations Receiving Broadcasts This receiver lets you enter a station’s frequency directly by using the numeric buttons (direct tuning). If you don’t know the frequency of the station you want, see “Receiving broadcasts by scanning stations (automatic tuning)” on this page. Before you begin, make sure you have: •Connected an FM/AM antenna to the receiver as indicated on page 5. •Selected the appropriate speaker system. (See “Selecting the speaker system” on page 7.) 1Press POWER to turn on the receiver. 2Press TUNER. The last received station is tuned in. 3Press FM/AM to select FM or AM stations. 4Press DIRECT. 5Press the numeric buttons to enter the frequency. Example 1: FM 102.50 MHz Example 2: AM 1350 kHz (You don’t have to enter the last “0.”) 6When you tune in AM stations, adjust the direction of the AM loop antenna for optimum reception. To receive other stations Repeat Steps 3 to 5. If the STEREO indicator remains off Press FM MODE when an FM stereo broadcast is received. If an FM stereo program is distorted The STEREO indicator flashes. Press FM MODE to change to monaural (MONO). You will not have the stereo effect but the distortion will be reduced. To return to stereo mode, press this button again. If you cannot tune in a station and the entered numbers are flashing Make sure you’ve entered the right frequency. If not, press DIRECT and re-enter the frequency you want. If the entered numbers still flash, the frequency is not used in your area. To watch FM simulcast TV programs Make sure that you tune in the simulcast program both on the TV (or the VCR) and on the receiver. If you enter a frequency not covered by the tuning interval The entered value is automatically rounded up or down to the closest covered value. Tuning intervals for direct tuning are: FM:50 kHz intervals AM:10 kHz intervals (to change to 9 kHz intervals, see page 13) Receiving broadcasts by scanning stations (automatic tuning) If you don’t know the frequency of the radio station you want, you can have the receiver scan all the receivable stations to locate the one you want. 1Press TUNER. The last received station is tuned in. 2Press FM/AM to select FM or AM. 3Press TUNING + or –. Press the + button for a higher station number; press the – button for a lower one. When you tune past either end of the band, the receiver automatically jumps to the opposite end. Every time a station is received, the receiver stops scanning. To continue scanning, press the button again. VOLUMEPOWERNumeric buttons DIRECTTUNERTUNING +/– FM/AM 10250 13510EN Receiver Operations Presetting Radio Stations You’ll most likely want to preset the receiver with the radio stations you listen to often so that you don’t have to tune in the station every time. The receiver can store a total of 30 FM or AM stations. You can store the stations on preset numbers combining 3 characters (A, B, C) and numbers (0 - 9). Fo... »