Notice GEEMARC AmpliDECT 250

« book Create an entry 26 View entries 26 Delete an entry 27 Clear all entries 27 Modify an entry 28 Caller Display (CID) Dial from CID list 29 Voice mail and CID list 30 Waiting call indicator 30 Delete entries in CID list 31 Clear all entries 31 Transfer from CID list to phone book 32 Additional handsets /base Add a new handset 33 Release a registered handset 33 Make an internal call 34 Call transfer between Handsets 34 Conference call 35 Add an extra base 35 Troubleshooting 36 Index General information Warranty 38 Recycling instruction 39 4 Description 5 Description 6 Description In standby mode, handset number, user name (if stored), time and date are all displayed on the LCD Description 7 When you want to create an entry e.g. name, phone number, you will need to use the keypad. Every key on the keypad represents a set of letters, numbers and symbols. See the table above. Use ‘C’ to correct a mistake i.e. clear the last digit entered Use * key to move from uppercase to lowercase Characters List 8 Note: If you are unsure what to do whilst in the menu system, stop pressing keys and simply wait 30 seconds, the telephone will automatically return to standby mode. Menu 9 1 - Connection Connect the line cord plug to the line socket on the base. Connect the other end of the line cord to the PTT socket. (**) Plug the power cable into the power socket on the base. Plug the adaptor into the mains supply. (*) 2 – Battery installation Install the rechargeable batteries in the handset. The handset requires three Nickel Metal Hydride (NiMH) AAA batteries. These are supplied with your telephone. Check the battery polarity diagrams on the handset when inserting the batteries. Fit the battery cover by sliding the cover on to the back of the handset until it snaps shut 3- Battery status Place the handset on the base, a short beep will be heard. The Power/Charging indicator lights up (red). The battery symbol will be displayed on the handset. Once the handset is fully charged, the display will show a full battery symbol. Installation 10 The telephone has an automatic charging control to avoid excessive charging. Before the handset can be used, the handset batteries must be charged for a minimum of 15 hours on the base. Note: When batteries get low during a call, there will be a warning tone (beep), you will have to place the handset on the base to recharge (*) Classified "hazardous voltage" according to EN60950 standard (**) Classified TNV-3 according to EN60950 standard. Installation 11 1- Handset On/Off When the handset is placed on the charger it automatically switches ON. Otherwise press key until it switches ON To turn the handset off, press key until 'Good Bye' appears. The LCD display will then switch off . 2- Key lock When this feature is turned on, all buttons except for , will be locked and will not function. Incoming or intercom calls can be answered by using key. However, when you complete the call and hang up, the telephone returns to lock mode. This feature is useful to avoid pressing buttons by mistake.... »