Notice GEEMARC PhotoPhone 100

« This is an amplified big button telephone The large button keypad is easy to see and use, it helps to prevent any misdialling. There are photo dial buttons, also designed to make dialling easier because you will be able to identify these speed dial buttons with pictures of your friends and family. This telephone is compatible with hearing aids. Its is important that you read the instructions below in order to use your Geemarc telephone to its full potential. Keep this user guide in a safe place for future reference. This guide explains how to use the following telephone: PHOTOPHONE 100 3 Unpacking the Telephone When unpacking the telephone, you should find the following in the box: • 1 PHOTOPHONE 100 unit • 1 PHOTOPHONE 100 handset with curly cord • 1 Telephone line cord • 1 User Guide INTRODUCTION For product support and help visit our website at www.geemarc.com Telephone 01707 384438 Or fax 01707 372529 4 DESCRIPTION General Description Hook Switch Tone reception adjustment Special memory (M1~M3) Store button Volume reception adjustment Direct memory Redial/Pause button Flash button Amplify button Mute button Amplify LED Speaker button Mute LED In use LED 5 DESCRIPTION Flash time Switch Speaker volume control Handset cord jack Ringer volume ith Phone line cord jack Amplify switch 6 INSTALLATION Setting Up Connect the handset to one end of the curly cord. Plug the other end of the curly cord into the jack on the left hand side of the PHOTOPHONE 100 unit. Place the handset on the cradle. Connect the line cord to the jack located at rear of telephone then connect the plug at the other end of the line cord into the wall socket *. (*) Classified TNV-3 according to EN60950 standard 7 INSTALLATION Wall Mounting Slide the handset hanger tab out and reverse its position (rotate it 180 degrees). Slide it back into place so that the hook points up (see diagram 1). This will keep the handset from falling out of the cradle when it is mounted on the wall. Install two self-tapping screws (not supplied) at a distance of 80 mm from each other and located on a vertical line. Place the phone onto the screw-heads and slide down to secure (see diagram 2). Turn the hook in the receiver cradle so that the receiver can be placed on-hook. Diagram 1 Diagram 2 8 SETTINGS Ringer Settings A switch located on the rear of the PHOTOPHONE 100 unit allows the ringer volume to be switched to HI (maximum volume), LO (lowest volume) or OFF (if you would prefer not to be disturbed). Flash (Recall) Setting You can adjust the flash time by using the switch located on the right side of your telephone phone. There are three levels available, 100ms, 270ms and 650 ms. Your telephone works with a flash time for United Kingdom (R=100ms). 9 SETTINGS Receiving Volume and Tone Settings You can alter the receiving volume and tone during a conversation according to your hearing requirements. Use the Volume slide control found at the top of the... »