Notice THOMSON WHP 265

« period. •Ventilation,Heat,Humidity - Protect the unit from dust,humidity and sources of excessive heat (such as a fireplace or radiator).The appliance should not be in contact with liquids or exposed to the risk of dripping or splashing.Therefore be careful not to place any object containing a liquid (vase,glass,bottle,...) on or near your appliance.Do not expose it to direct sunlight.Its maximum ambient operating temperature is 35°C. The ventilation should not be impeded by covering the ventilation openings or the device itself with items such as,newspapers,tablecloths,curtains,etc.No naked flame sourced, such as lighted candles should be placed on,or close to,the device. •Your unit is designed for use in a dry environment.If for exceptional reasons you must utilise it out of doors (balcony,veranda,etc.) take care to protect it from dampness (dew,rain,splashes). The maximum ambient humidity that the device supports is 85%.If your unit is cold and you wish to use it in a warm room,wait until any condensation on the unit evaporates by itself before you switch it on. •You must only clean your unit using a soft cloth soaked in a neutral detergent.You may damage your unit if you use solvent or an alcohol-based product.If you are unsure,test the cleaning product on the underside of the unit. THOMSON declines all liability for any use that does not comply with this instruction notice. en WHP 265 - 16 langues 14/05/03 12:08 Page 12 Connections WHP 265 - 16 langues 14/05/03 12:08 Page 2Placing in operation About your WHP 265 Your WHP 265 comprises a cordless headset and an infra-red transmitter.Its range ofoperation corresponds to the typical use of such products.See illustration (B)inside for itsrange of operation and then follow the instructions in this leaflet.See also the connectiondiagram on page 2. Your headset is fully autonomous thanks to two AAA batteries that you need to install ineach earpiece of the headset.The foam rubber of each earpiece slides out to allow you todo this. Installing the transmitter 1 Place the transmitter (1) in proximity to the source (television,amplifier,etc.) taking careto aim the LED diodes in the direction of the area where you will be listening and takingcare that there are no intervening obstacles (objects,people,animals,etc.). 2 Plug the AUDIO cable plug (5) into the headset/earphones output of the source. 3 Plug the AC-DC (3) plug into the DC IN of the transmitter (1) then plug the adaptor intoa 230 V,50 Hz mains socket. Putting the headset in service 1 Slide out the rubber foam from each earpiece sufficiently to install two AAAbatteries,taking care to place them pointing in the correct direction,so that the polarity isrespected.The direction is marked inside the compartments (+ and -).Refit the foamrubber.Take care in fitting it (there are 2 hooks and 2 lugs).Do not force it,sliding intoplace is possible without forcing. 2 Plug the CHG.OUT (4) cable from the transmitter (1) into the headseat (10) and placethe ON/OFF button on the headset (8) to OFF. 3 Turn on the transmitter (1) by placing the POWER button (2) to ON. Charging the rechargeable batteries The rechargeable batteries must be fully charged for 20 at 24 hours before use.While theunit is being charged,the red indicator light is lit (11).After the unit has been charged forthe first time,it must be charged for approximately 12-14 hours. Non-rechargeable batteries may be used in place of the rechargeabl... »