Notice NUMARK CDN95

« gram. 4. Place mixer in an appropriate position for operation. 5. Make sure all devices are turned off and all faders and gain knobs are set to “zero” 6. Connect all stereo input sources as indicated in the diagram, your microphone, and headphones 7. Connect the stereo outputs to power amplifier(s), tape decks, and/or other audio sources. 8. Plug all devices into AC power. 9. Switch everything on in the following order. • audio input sources (i.e. turntables or CD players) • mixer • last, any amplifiers or output devices 10. When turning off, always reverse this operation by, • turning off amplifiers • mixer • last, any input devices 11. Go to http://www.numark.com for product registration. More information about this product may be found at http://www.numark.com FEATURES: 1. PLAY/STUTTER- To start the music from the initial cue point. 2. PAUSE- To pause the music. 3. CUE- To move the music to the cue point and preview the selection. 4. JOG WHEEL- a. INNER WHEEL- Used for various functions such as cueing, scratching, pitch bend, searching, and effect control b. OUTER PITCH WHEEL (AXIS 9) - Used for temporary pitch bend. 5. LCD DISPLAY- Indicates all the functions, as they are occurring, with the CD. 6. OPEN/CLOSE- Pressing will open or close the disc tray on the transport. 7. SGL- To set play mode in single or continuous play. 8. TIME- Controls display indication of time mode. 9. PROGRAM- Used for setting track order and various special commands. 10. TRACK SELECT/SEARCH- c. Rotation – selects tracks d. Pressing while rotating – selects tracks +10 e. Pressing once- Puts wheel in search mode. 11. PITCH- Actives and sets pitch slider range. 12. KEY- Used for various key control. 13. -,+ - Works as pitch bend and controls key and pitch functions. 14. PITCH SLIDER- Controls the overall speed of the music. 15. PITCH RANGE LED- Indicates current pitch range of the pitch slider 16. EFFECT BUTTON- Used to determine desired effect. 17. EFFECT HOLD- Used to set effects to an alternate position 18. LOOP IN- Used to set stutter and loop in points. 19. LOOP OUT- Used to set loop out points and release the loop. 20. RELOOP/STUTTER- Used for repeated play (stutter) from the loop in point, repeating a previously set, and hot start. 21. RELAY- Used for setting Alternating play start between attached units. 22. & 23. BEAT SYNC with MARCHING BAR GRAPH- Tracks the beats and measure position of music 24. INTERLOCK- Links both players for beat alignment. 25. Slot Load CDRW Drive – designed to play commercially available CD and properly burned CDR and CDRW discs. Insert the CDs you wish to play here. 26. Disc Indicator – illuminates when disc is in Drive. 27. Eject Button - used to eject CDs from the player. The CD will only eject when it is not playing. 28. Power Switch- Turn on and turn off the machine with this button. The unit should always be shut down with this button first before any external power is removed. Typically it is recommended that the CD player is powered on before amplifiers and off after amplifiers to avoid an audio spike to be sent through your equipment. 29. IEC Power Plug Connector - Plug your supplied power cord in here. 30. Control Cable Connector- Plug in the 8-pin cable included in here to connect th... »