Notice NUMARK CDX 1

« CD PLAYER QUICK SETUP (ENGLISH) 1. Make sure all items listed on the front of this guide were in the box. 2. READ SAFETY INSTRUCTION BOOKLET BEFORE USING THE PRODUCT. 3. Assemble unit following the Quick Assembly Instructions. 4. Study this setup diagram. 5. Place the unit in an appropriate position for operation. 6. Make sure all devices are turned off and all faders and gain knobs are set to “zero” 7. Connect all stereo input sources as indicated in the diagram, your microphone, and headphones 8. Connect the stereo outputs to power amplifier(s), tape decks, and/or other audio sources. 9. Plug all devices into AC power. 10. Switch everything on in the following order. • audio sources (i.e. turntables or CD players) • mixer • last, any amplifiers or output devices 11. When turning off, always reverse this operation by, • turning off amplifiers • mixer • last, any audio sources 12. Go to http://www.numark.com for product registration. More information about this product may be found at http://www.numark.com 1. Power Switch - turns on and off the machine. The unit should always be shut down with this button first before any external power is removed. Typically, it is recommended that the CD player is powered on before amplifiers and off after amplifiers to avoid an audio spike to be sent through your equipment. 2. Slot Load CDRW Drive – designed to play commercially available CD and properly burned CDR and CDRW discs. Insert the CDs you wish to play here. 3. Eject Button - used to eject CDs from the player. The CD will only eject when it is not playing. 4. Track/Menu Select Knob Track – Rotate to select tracks. Pressing while rotating selects tracks +10 Menu Select – Press “Menu” then rotate to move through menu options. Pressing selects options. 5. High Torque Direct Drive Platter - utilizes a 5.0 kgf-cm motor to turn the vinyl record. The platter should not be held in position for sustained periods. 6. Vinyl Record – controls the playback of the music, including scratching, pitch bend and cueing. 7. Play/Pause Button – starts and stops playback and the platter. Pressing toggles between play and pause of the platter. Each time Play is pressed after Pause, a new Cue Point is set. 8. Brake Adjust – changes the amount of time it takes for the platter to stop when the Pause button is pressed. As the wheel is moved right the braking time increases. For fast braking move the wheel all the way left. 9. Startup Adjust - changes the amount of time it takes for the platter to start when the Play button is activated. As the wheel is moved right the startup time decreases. For fast startup move the wheel all the way left. 10. Cue Button- returns and pauses the music at the last set Cue Point. The Cue Point is the last place in which the unit was paused and then Play or Stutter was pressed. Pressing a second time allows for temporary play of this point. You can easily edit the cue point by turning the wheel while paused. As you rotate the wheel the music will sound. By stopping the wheel and pressing Play, a new point is set. 11. Stutter Button – starts the music from either the first set Cue Point or the last point of pause. If you start from the last pause point while the unit is paused, a new Cue Point is set. Pressing this button while the unit is in Play restarts the unit from... »