Notice NUMARK MP102

« ram. 4. Place MP102 in an appropriate position for operation. 5. Make sure all devices are turned off and all faders and gain knobs are set to “zero” 6. Connect all stereo input sources as indicated in the diagram. 7. Connect the stereo outputs to power amplifier(s), tape decks, and/or other audio sources. 8. Plug all devices into power. 9. Switch everything on in the following order: • audio input sources (i.e. turntables or CD players) • MP102 • last, any amplifiers or output devices 10. When turning off, always reverse this operation by, • turning off amplifiers • MP102 • last, any input devices 11. Go to http://www.numark.com for product registration. More information about this product may be found at http://www.numark.com REAR CONNECTIONS 1. XLR Balanced Audio Connectors – Low impedance XLR output connectors. 2. Power Plug Connector - Plug your supplied power cord in here. 3. Voltage Selector - Set this switch to the voltage for your location. 4. RCA Audio Connectors - Connect your CD player to your mixer from this line level output. 5. Digital Output - The format is type 2, form 1, also known as S/PDIF (Sony/Phillips Digital Interface Format). In order to use the digital output you should not use variable pitch slider and the pitch bend buttons. If you adjust the pitch, other devices may not read the digital output properly because the sampling rate changes 3 CD PLAYER FEATURES 1. OPEN/CLOSE (Disc Tray Open/Close) - Press to load or eject the disc. Each press will open or close the disc tray on the transport. NOTE: Tray will not open unless the disc has been paused. Tray will automatically close after 30 seconds. 2. TIME (Time Button) - Switches the time display between elapsed playing time and remaining time on the track and remaining time on the entire CD. 3. CONT/SING - Will cause just a single track to play or all tracks in order by pressing once or twice. 4. LCD DISPLAY - Indicates all the functions, as they are occurring, with the CD. These functions are explained in the next section. 5. TRACK (Track Buttons) - Used to select the track to be played. 6. Folder/+10 Button – Steps up or down through folders on MP3 discs. On a disc which contains no folders, this button advances the track by 10. 7. PROGRAM - Depress this button and the unit will stop and the program indicator will light. Select each track to be programmed and press the PROGRAM button between selections. You can program up to 20 tracks. Press PLAY to start the program. To exit and erase program, either hold the program button down for more than 2 seconds while the unit is stopped, open the disc tray, or turn off the power. 8. PITCH (Pitch Button) - Activates the Pitch Slider. To alternate between ±8% and ±16%, press and hold the PITCH button. The LED will indicate the pitch setting. 9. PITCH SLIDER - The pitch can be changed up to ±16% by pressing the PITCH button so the PITCH LED is lit, then moving the sliding fader. The pitch will not be changed if the PITCH LED is off. 10. SEARCH WHEEL (OUTER RING) - 3 forward and 3 reverse speed positions for searching through songs. The more you turn the wheel in either direction the faster you search through the music. 11. PITCH BEND/JOG WHEEL (INNER RING) - The jog wheel serves 2 function... »