Notice TANGENT Duo

« nce of 20 cm behind the unit. 4.Do not open the cabinet.Only qualified technicians are allowed clean the internal parts. 5.Make sure thatliquid and foreign matter cannot penetrate the unit. 6.If service or repair is required,this must be carried out by qualified technicians. 7.Unplug the unit in the following cases: A.The mains plug or the mains cable is defective. B.Foreign matter or liquid has penetrated the radio. C.The unit cannot be operated properly. D.The unit has fallen down or the cabinet has been damaged. 8.Store this instruction manual carefully for future reference. 9.Use a duster or a slightly damp,soft and non-fluffy rag to clean the radio. 10.Do not use corrosive or strong cleaning agents.Make sure that no moisture penetrates the radio during cleaning.Unplug the unit before cleaning. 11.Check that the mains voltage indicated on the back of the clock radio corresponds to the mains voltage that the unit is connected to. 12.Unplug the unit if the clock radio is not to be used for a long time. Disclaimer Despite extensive efforts we cannot guarantee that the technical data indicated are correct,complete and updated.We reserve the right to make technical changes without notice. UKFRONT PANEL 04 UK05 UK 1.TUNING:Turn the tuning knob to the right or to the left to change the frequency range. 2.FREQUENCY SCALE:Shows both the AM and the FM frequency of the tuned channel. 3.VOLUME:Turn the volume knob to the right to increase the volume or to the left to decrease the volume of the speakers.This knob will also control the volume of headphones when connected. 4.POWER LIGHT:Glows green when the unit is active. 5.TUNING INDICATOR:The tuning indicator will appear brightest when best tuning has been achieved.Some weak,but listenable AM stations will not light the tuning indicator and should be tuned for loudest and clearest signal. 6.OFF/FM/AM/AUX:Turn the knob 1 click to the right to select the FM band,2 clicks to the right to select the AM band and 3 clicks to the right to activate the AUX input.Turn the knob all the way to the left to turn off the radio. 7.SLEEP FUNCTION:Press this button when the alarm has been set to listen to FM or AM for approximately 20 minutes.After 20 minutes the radio will turn off by it self.The sleep indicator will glow green when the function is activated. the green sleep indicator will keep on glowing after the sleep function has been performed.To turn the sleep indicator off,you must push the sleep button once again. 8.SLEEP FUNCTION INDICATOR:Glows green when the sleep function is activated. 9.ALARM ON/OFF INDICATOR:Glows green when the alarm is activated. NOTE:The light is weak in the sleep and alarm indicators,in order not to lighten up a dark sleeping-room 10.ALARM SWITCH:Sets the alarm on or off.Set the wakeup time to the preferred time using the alarm thumbwheel.Select FM or AM and push the alarm switch.The alarm indicator will start to glow green.When the selected time is reached,the radio will start to play the selected station.If the alarm switch is activated in OFF or AUX mode,the alarm will beep when the selected time is reached. NOTE:If the electricity goes out,the radio won't play,but you will hear the alarm beaps. 11.CLOCK:Remember to check the battery annually so the clock stays accurate. 12.CLOCKTHUMBWHEEL:Rotate the thumbwheel counter clockwise until the alarm hand points at the time you wish the alarm to star... »