Notice ZYXEL P-660HN

« u set up your P-660HN. • Internet access - account information provided by your ISP, such as user name and password. • Internet Explorer 6.0 or later or Netscape Navigator 7.0 or later, with JavaScript enabled. See the User’s Guide for all configuration details. To read the User’s Guide, insert the CD that came in the box into your CD-ROM drive. A screen should pop up. Navigate to the User’s Guide from this screen. If a screen does not pop up, open Windows Explorer (click My Computer), click on the CD-ROM drive (usually drive D) and navigate to it from there.ENGLISHENGLISH 5 Hardware Connections 1. DSL: Use a telephone wire to connect this port to a telephone jack. 2. ETHERNET 1-4: Use an Ethernet cable to connect a computer to this port for initial configuration and/or Internet access. 3. POWER: Use the power adaptor provided with your P-660HN to connect an appropriate power source to this socket. 4. Push the power switch to the on position. Make sure to remove the plastic sheet on the top panel.ENGLISH 6 Look at the LEDs (lights) on the top panel of the P-660HN. • The POWER light blinks during start-up and is green once the P-660HN is ready. • Each ETHERNET light turns on if the corresponding ETHERNET port is properly connected. The lights blink when the P-660HN is sending or receiving data through the corresponding ETHERNET port. • The WLAN/WPS light turns on when the wireless LAN is ready. It blinks when the P-660HN is sending/receiving data through the wireless LAN. • The DSL light stays on if a physical DSL connection exists and blinks when the P-660HN is initializing the DSL line. • The INTERNET light stays on when Internet access is available and blinks when there is data transmitted. Launch your web browser and navigate to any web site (for example, www.zyxel.com). The P-660HN automatically detects and configures your Internet connection. This may take about two minutes. ENGLISHENGLISH 7 If you have a PPPoE or PPPoA connection, a screen displays prompting you to enter your Internet account information. Enter the username, password and/or system password (1234 by default) exactly as provided. Click Apply. If the INTERNET light is off but the DSL light is on, go to Internet/Wireless Setup on page 8 and use the wizard to configure your Internet access settings. If none of the LEDs (lights) are on, check your connections. Make sure that you have the power adaptor connected to the P-660HN and plugged in to an appropriate power source. Make sure the power source is turned on. Turn the P-660HN off, wait for a few seconds and turn it back on. If the LEDs are still off, contact your local vendor.ENGLISH 8 Internet/Wireless Setup 1. Open your browser and enter http://192.168.1.1 (the P-660HN's default IP address) as the address. 2. Enter the admin password 1234 and click Login. If the login screen does not display, make sure you allow web browser pop-up windows, JavaScripts and Java permissions. Your computer should be also set to get an IP address automatically from a DHCP server. See the appendices in your User’s Guide for more information.ENGLISHENGLISH 9 3. It is strongly recommended that you change the admin password in the following screen. If you change it, you will not see this screen the next time you log in. 4. Click Apply to replace the P-660HN’s default digital certificate. The certificate is used for authenti... »