Notice PIONEER CDVS33

« io/Video equipment............9 Installation ................................................10 Installing Hide-away Unit ..............................10 Installing Controller Unit ................................11 Part Names And Applications ..............14 Controller Unit ................................................14 Hide-away Unit................................................15 Specifications ..........................................16 ENG/MASTER 96 20080403CD-VS33-E.Q3.3E 08.4.22 9:50 AM Page 2Before Using this Product About this Product This product is a rear-seat audio-video selector that enables you to switch the display between audio and video. When using this product We recommend that you familiarize yourself with the functions and their operation by reading through the manual before you begin using this product. It is especially important that you read and observe the “Precaution” on this page and in other sections. Precaution •Keep this manual handy as a reference for operating procedures and precautions. •Protect this product from moisture. •Do not set a high volume level when using headphones to listen. Listening to high vol- umes for extended periods of time can have an adverse effect on hearing. 2 ENGLISHESPAÑOLDEUTSCHFRANÇAIS ITALIANONEDERLANDS ENG/MASTER 96 3 WARNING •Handling the cord on this product or cords associated with accessories sold with the product may expose you to chemicals listed on proposition 65 known to the State of California and other governmental entities to cause cancer and birth defects or other reproductive harm. Wash hands after handling. •Connect the product to a display that cannot be seen by the driver. If the display can be installed only where it is visible to the driver, use a display that can detect the ON/OFF status of the parking brake, and be sure to install the display correctly so that it always works in conjunction with the parking brake switch. •To avoid the risk of accident and the potential violation of applicable laws, this product is not for use with a video screen that is visible to the driver. •In some countries or states the viewing of images on a display inside a vehicle even by persons other than the driver may be illegal. Where such regulations apply, they must be obeyed. 20080403CD-VS33-E.Q3.3E 08.4.22 9:50 AM Page 34 3 Connecting the Units Note: •This product is for vehicles with a 12-volt battery and negative grounding. Before installing it in a recreational vehicle, truck, or bus, check the battery voltage. •To avoid shorts in the electrical system, be sure to disconnect the ?battery cable before beginning installation. •After completing installation and wiring, double check that there are no mistakes. Re-install any parts removed from the car during installation, then connect the battery negative terminal. •Refer to the owner’s manual for details on connecting the various cords of the power amp and other units, then make connections correctly. •Secure the wiring with cable clamps or adhesive tape. To protect the wiring, wrap adhesive tape around them where they lie against metal parts. •Route and secure all wiring so it cannot touch any moving parts, such as the gear shift, handbrake and seat rails. Do not route wiring in places that get hot, such as near the heater outlet. If the insulation of the wiring melts or gets torn, there is a danger of the wiring short-circuiting to the vehicle body... »