Notice PIONEER VSX-LX53

Notice PIONEER VSX-LX53

Mode d'emploi PIONEER VSX-LX53 disponible.

Groupe d'entraide des utilisateurs PIONEER VSX-LX53

Bienvenue dans le groupe d'entraide des utilisateurs
PIONEER VSX-LX53

7.1

Le groupe d'entraide PIONEER VSX-LX53 vous donne des conseils d'utilisation, solutions aux problèmes de fonctionnement, entretien et assistance pour votre Amplificateur. Rejoignez GRATUITEMENT notre groupe d'entraide VSX-LX53 pour vous aider à mieux utiliser votre Amplificateur PIONEER. Le SAV entre consommateurs donne accès à différents services pour votre PIONEER VSX-LX53 : accès à la notice VSX-LX53 et mode d'emploi pdf, manuel d'utilisation en français, avis consommateur et forum actif. Soyez le premier membre actif de ce groupe d'entraide.

PIONEER VSX-LX53

Dernières actualités du groupe d'entraide PIONEER VSX-LX53

Nouvelles questions du forum

Lancez la discussion

Nouveaux membres

  • nogopet376  depuis le 15/12/2020 - Expertise (non renseigné) - Utilisateur depuis (non renseigné)
  • Laure-DaraSaignavongs  depuis le 31/12/2013 - Expertise débutant - Utilisateur depuis plus de 5 ans

Documentation disponible sur votre produit

Notice disponible après inscription gratuite au groupe d'entraide

Manuel/Notice/Mode d'emploi | 8 118 K | Français

Pas de vidéo disponible

« should be performed only by qualified service personnel. IMPORTANT: THE MOULDED PLUG This appliance is supplied with a moulded three pin mains plug for your safety and convenience. A 10 amp fuse is fitted in this plug. Should the fuse need to be replaced, please ensure that the replacement fuse has a rating of 10 amps and that it is approved by ASTA or BSI to BS1362. Check for the ASTA mark or the BSI mark on the body of the fuse. If the plug contains a removable fuse cover, you must ensure that it is refitted when the fuse is replaced. If you lose the fuse cover the plug must not be used until a replacement cover is obtained. A replacement fuse cover can be obtained from your local dealer. If the fitted moulded plug is unsuitable for your socket outlet, then the fuse shall be removed and the plug cut off and disposed of safely. There is a danger of severe electrical shock if the cut off plug is inserted into any 13 amp socket. If a new plug is to be fitted, please observe the wiring code as shown below. If in any doubt, please consult a qualified electrician. IMPORTANT: The wires in this mains lead are coloured in accordance with the following code: Blue : Neutral Brown : Live As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows; The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or coloured BLACK. The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L or coloured RED. How to replace the fuse: Open the fuse compartment with a screwdriver and replace the fuse. WARNING This equipment is not waterproof. To prevent a fire or shock hazard, do not place any container filled with liquid near this equipment (such as a vase or flower pot) or expose it to dripping, splashing, rain or moisture. D3-4-2-1-3_A1_En WARNING Before plugging in for the first time, read the following section carefully. The voltage of the available power supply differs according to country or region. Be sure that the power supply voltage of the area where this unit will be used meets the required voltage (e.g., 230 V or 120 V) written on the rear panel. D3-4-2-1-4*_A1_En Operating Environment Operating environment temperature and humidity: +5 °C to +35 °C (+41 °F to +95 °F); less than 85 %RH (cooling vents not blocked) Do not install this unit in a poorly ventilated area, or in locations exposed to high humidity or direct sunlight (or strong artificial light) D3-4-2-1-7c*_A1_En WARNING To prevent a fire hazard, do not place any naked flame sources (such as a lighted candle) on the equipment. D3-4-2-1-7a_A1_En VSX-LX53_QuickGuide_SVYXJ_ENFRDE.book Page 2 Tuesday, February 23, 2010 8:22 PMInformation for users on collection and disposal of old equipment and used batteries These symbols on the products, packaging, and/or accompanying documents mean that used electrical and electronic products and batteries should not be mixed with general household waste. For proper treatment, recovery and recycling of old products and used batteries, please take them to applicable collection points in accordance with your national legislation. By disposing of these products and batteries correctly, you will help to save valuable resources and prevent any potential negative e... »

Activité de ce groupe d'entraide

Note moyenne du groupe
5 étoiles
Durée moyenne d’utilisation
Avis consommateur
1 avis
Aucune discussion
Lancez la discussion !
Aucune opinion sur PIONEER
Donner votre opinion sur PIONEER
En cours...