Notice EPSON TM H6000III

« 2-1Handshaking (BUSY condition) Receive buffer full Offline or Receive buffer full 2-2Customer display connection ConnectedNot connected 2-3 2-4 Print densitySee Table A. 2-5 2-6 Internal use. Fixed to Off. 2-7I/F pin 6 reset EnabledDisabled 2-8I/F pin 25 reset EnabledDisabled Transmission speed (bps)-bits per second1-71-8 4800ONON 9600OFFON 19200ONOFF 38400OFFOFF Parallel SWFunctionONOFF 1-1Auto line feedAlways enabled Always disabled 1-2Receive buffer capacity 45 bytes4 KB 1-3~ 1-8 Reserved. Fixed to Off. 2-1Handshaking (BUSY condition) Receive buffer full Offline or Receive buffer full 2-2Internal use. Do not change setting. Fixed to Off. 2-3 2-4 Print densitySee Table A. 2-5 2-6 Internal use. Fixed to Off. 2-7Reserved (for serial interface) Fixed to Off. 2-8I/F pin 31 reset signal. Do not change setting. Fixed to On. Table A Print density/low powerSW 2-3SW 2-4 1 Print density (Light)ONON 2OFFOFF 3ONOFF 4 Print density (Dark)OFFONTM-H6000III User’s Manual1 English English TM-H6000III User’s Manual All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of Seiko Epson Corporation. No patent liability is assumed with respect to the use of the information contained herein. While every precaution has been taken in the preparation of this book, Seiko Epson Corporation assumes no responsibility for errors or omissions. Neither is any liability assumed for damages resulting from the use of the information contained herein. Neither Seiko Epson Corporation nor its affiliates shall be liable to the purchaser of this product or third parties for damages, losses, costs, or expenses incurred by purchaser or third parties as a result of: accident, misuse, or abuse of this product or unauthorized modifications, repairs, or alterations to this product, or (excluding the U.S.) failure to strictly comply with Seiko Epson Corporation’s operating and maintenance instructions. Seiko Epson Corporation shall not be liable against any damages or problems arising from the use of any options or any consumable products other than those designated as Original Epson Products or Epson Approved Products by Seiko Epson Corporation. Epson and ESC/POS are registered trademarks of Seiko Epson Corporation. NOTICE: The contents of this manual are subject to change without notice. Copyright © 2005 by Seiko Epson Corporation, Nagano, Japan.2TM-H6000III User’s Manual English EMC and Safety Standards Applied Product Name: TM-H6000III Model Name: M147G The following standards are applied only to the printers that are so labeled. (EMC is tested using the Epson power supply.) Europe:CE marking Safety:EN 60950 North America:EMI:FCC/ICES-003 Class A Safety:UL 1950/CSA C22.2 No. 950 Japan:EMI:VCCI Class A Oceania: EMC:AS/NZS CISPR22 Class B WARNING The connection of a non-shielded printer interface cable to this printer will invalidate the EMC standards of this device. You are cautioned that changes or modifications not expressly approved by Seiko Epson Corporation could void your authority to operate the equipment. CE Marking The printer conforms to the following Directives and Norms: Directive 89/336/EECEN 55022 M147G Class B EN 55024 IEC 61000-4-2 IEC 61000-4-3 IEC 610... »