Notice SONY Reader PRS-T1 Wi-Fi

« o your Reader via the Reader software. For details on how to install the software, refer to the User Guide. Set up a Wi-Fi® network connection with these simple steps. JOIN A Wi-Fi® NETWORK Your Reader must be configured to connect to a Wi-Fi network for a wireless Internet access. INTERNET INTERNET The following questions will determine the most suitable case for setting your Reader for a Wi-Fi network connection. Case A Case DNO1. Are you using a home Wi-Fi connection? YES YES YES Case CNO2. Is your Wi-Fi router WPS* compatible? Case BNO3. Does your Wi-Fi router have a WPS button? First, follow the COMMON INSTRUCTIONS below, then refer to your case for further instructions. COMMON INSTRUCTIONS 1. Tap [Wireless Network Settings] under [Settings] on the second page of the [Home] screen on your Reader. 2. Confirm [Wi-Fi] has its check mark. Otherwise, turn on Wi-Fi by tapping [Wi-Fi]. 3. Tap [Wi-Fi Settings] to show the [Wi-Fi Settings] screen. CASE A: A WPS-compatible Wi-Fi router with WPS button Note: Make sure that your Reader shows the [Wi-Fi Settings] screen. Otherwise, follow the steps under COMMON INSTRUCTIONS first. 1. Tap [WPS Push-Button Configuration]. 2. Tap [Start]. 3. Press the WPS button on your Wi-Fi router within 2 minutes. 4. After your Reader screen shows the setup completion, tap [OK]. CASE B: A WPS-compatible Wi-Fi router with PIN Input Note: Make sure that your Reader shows the [Wi-Fi Settings] screen. Otherwise, follow the steps under COMMON INSTRUCTIONS first. 1. Tap [Add Wi-Fi Network]. 2. Tap [WPS PIN Method]. 3. Tap [Start]. A PIN (Personal Identification Number) will be shown on the screen of your Reader. 4. Enter the PIN into your Wi-Fi router. Please refer to your Wi-Fi router’s instruction manual for further details. 5. After entering the PIN tap [OK]. Your Wi-Fi router’s SSID (Service Set Identifier) appears in the [Wi-Fi Networks] list on the [Wi-Fi Settings] screen. 6. Tap your Wi-Fi router’s SSID and tap [Connect]. CASE C: Connecting to a Wi-Fi router without WPS support Note: Make sure that your Reader shows the [Wi-Fi Settings] screen. Otherwise, follow the steps under COMMON INSTRUCTIONS first. Check if the Wi-Fi router to be connected requires a password. A password may also be called a WEP key/WPA key/encryption key/network key, or similar. 1. Tap [Scan] to show a list of all available Wi-Fi networks. 2. Find and tap your Wi-Fi router’s SSID (Service Set Identifier) in the [Wi- Fi Networks] list. 3. If prompted for a password, tap the input area and type in the password using on-screen keyboard. 4. Tap [Connect]. CASE D: Connecting to an available Wi-Fi network Note: Make sure that your Reader shows the [Wi-Fi Settings] screen. Otherwise, follow the steps under COMMON INSTRUCTIONS first. Check if the available Wi-Fi network requires a username and a password. A password may be also called a WEP key/WPA key/encryption key/ network key, or similar. 1. Tap [Scan] to show a list of all available Wi-Fi networks. 2. Find and tap your Wi-Fi network SSID (Service Set Identifier) in the [Wi- Fi Networks] list. 3. If prompted for a password, tap the input area and type in the password using the on-screen keyboard. 4. Tap [Connect]. 5. The [Browser] application may start automatically. Otherwise, start the browser application manually; press the (Home) button, tap [] or press the (Page Turn) button and tap [Browser].... »