Notice OLYMPUS FL-600R

« 6 Do not operate if the ? ash has been dropped or damaged - until it has been examined by quali? ed service personnel. Let ? ash cool completely before putting away. To reduce the risk of electric shock, do not immerse this ? ash in water or other liquids. To reduce the risk of electric shock, do not disassemble this ? ash, but take it to quali? ed service personnel when service or repair work is required. Incorrect reassembly can cause electric shock when the ? ash is used subsequently. The use of an accessory attachment not recommended by the manufacturer may cause a risk of ? re, electric shock, or injury to persons. SAVE THESE INSTRUCTIONS EN 7 Names of Parts (Fig. Names of Parts (Fig. p. 3) p. 3) 1 Wide panel 2 Light-emitting area 3 Remote sensor 4 AF illuminator/LED window 5 Auto light receptor 6 Catch light plate 7 Control panel 8 AUTO CHECK lamp 9 TEST button/CHARGE lamp 0 OK button a Bounce lock release button b BACK LIGHT button c ON/OFF button d Latch e Dial (a: ? ash compensation button; b: MODE button; c: LED light button; d: ZOOM button) Control PanelControl Panel (Fig. (Fig. p. p. 44)) Details Details ( (p.p. 11, 1811, 18)) 1 Super FP ? ash 2 Flash control mode 3 Guide number (GN) 4 Flash intensity control 5 Zoom position (angle of illumination) 6 FOUR THIRDS 7 Zoom mode 8 LED light 9 ISO sensitivity 0 RC mode group a Aperture (F) b RC mode channel c Temperature warning d Distance units Continuous FiringContinuous Firing The ? ash may become hot when ? red many times in succession, resulting in damage or malfunction. The ? ash should be ? red no more than 10 times in succession at intervals of 2.5 seconds, after which it should be left unused for at least 10 minutes. Preparing a Battery (Preparing a Battery (Sold SeparatelySold Separately)) Choose from the below batteries: • AA (R6) alkaline batteries (× 4) • AA (R6) NiMH batteries (× 4) x Note AA (R6) manganese batteries cannot be used. Thank you for purchasing this Olympus product. To ensure your safety, please read this instruction manual before use, and keep it handy for future reference. 8 EN Loading BatteriesLoading Batteries 1 Open the battery compartment cover. 2 Insert the batteries with correct +/– polarity. 3 Close the battery compartment cover. Attaching to the CameraAttaching to the Camera Con? rm that both the camera and electronic ? ash are off. Attaching or removing the electronic ? ash while either the ? ash or the camera is on may result in malfunction. 3 211 Slide the latch in the direction opposite to that indicated by the [LOCK] icon (1). 2 Slide the ? ash into the hot shoe until it clicks securely into place (2). 3 Slide the latch to the [LOCK] position (3). • To remove the ? ash, slide the latch in the direction opposite to the [LOCK] arrow and slide it from the shoe. EN 9 Turning on the Electronic FlashTurning on the Electronic Flash Attach an electronic ? ash to the camera, and then turn the camera on. CHARGE lamp AUTO CHECK lamp ON/OFF button Control panel1 Press the ON/O... »