Notice YOO DIGITAL BEERDRAFT100

« its service agent or a similarly qualified person in order to avoid a hazard. • Before use it, check whether the plug conform with the socket or not; if not, please don’t use it, and call service center; • Do not connect or disconnect the electric plug when your hands are wet. • Place the beer cooler on a dry and horizontal surface. • To ensure proper ventilation for the beer cooler, make sure the beer cooler is at least 5 inches / 10cm away on either side so as to allow correct ventilation on the appliance. • Never put the beer cooler under the sunlight. • Never cover the beer cooler when it is operating by some other object. • The beer cooler must be installed in an area protected from the elements, such wind, rain, water spray or drips. • Before proceeding with cleaning and maintenance operation, make sure the power line of the unit is disconnec- ted. Failure to do so can result in electric shock or death. • Do not immerse the beer cooler or power plug in the water or other liquid. • Do not use coarse cloth, abrasive stuff to clear the beer cooler • Do not take beer keg out from the beer cooler if the beer is not drunk out completely. • Do not take the CO2 cartridge off before the inside CO2 use out. • Do not use the CO2 cartridge if the room temperature is over 49?/120F. Failure to do so can result in explosion or death. • Never allow children to operate, play with or crawl inside the beer cooler.4 HOW TO SELECT A KEG ______________________________________________________________ • Sealed 5L universal keg and Pressurized keg applies only • Pay close attention to safety and storage messages about the keg / on the keg. • Check the keg is neither damaged nor beer out-of-date before purchasing. • Protect the top surface from being damaged. Otherwise it could be difficult of • accession for the suction tube. • Keep the keg in a rather cold for 12 hours but not too cold place (e.g. refrigerator) • until next use. • Never shake the keg before use • Never put the beer keg under the sunlight BEER KEG SEALANT ____________________________________________________________________ All 5 Liter beer keg with the below various appearance sealants can apply to the beer cooler, however, you should follow the information as below *The sealants with code No. 20 and 21 can be pierced simply by the cooler piercing pin. *The sealants with code No. 22 need to be removed off the marking ring from the sealant and pierce the keg by cooler piercing pin. (Show as figure 1) *The difference between code No 23 and 24 is the safety clasp quantity. Pull up the safety clasp carefully, turn around and take it out from the keg; replaced it by the sealant (like code No 2 sealant) provided in the beer cooler, attach it to the beer keg, and pierce it by cooler piercing pin. (Show as Figure 3). Figure 1ENGLISH 5 WARNINGImportant: Before replacing the sealants or piercing the cooler kit, you must always follow the instructions marked on the keg to eliminate the excess gas and ensure that the keg has rested long enough to avoid foam coming out through the cooler piercing pin /tap faucet. And it is no need to release the gas and replace the seal rubber if you use Pres- surized keg, because Pressurized keg has its own CO2 pressure inside, and no need to be provided from outer CO2 pressure system. Figure 2 Figure 3 Using your appliance... »