Notice COLEMAN Tonnelle moustiquaire Insta-Clip 11x13

« Pole Assembly – You will need to assemble and connect one pole at a time to the hub. – Do not completely assemble poles. a)Beginning at spring-clip end of pole, assemble all but the last shock-corded section. The pole and one section should curve downward. (illus. 2) b)Insert the spring-clip end into one of the hub ports until it clicks into position. (illus. 1), (illus. 2) c) Repeat for each of the three remaining poles. (illus. 2) 13’x11’ Insta-Clip Screen House 1 When You Are Ready To Set Up Your Shelter – Select a level area clear of rocks, branches and other hard or sharp objects. – Do not set up your shelter under trees. – For easier set up, two or more people are recommended. – Place fabric in center of selected location and assemble above fabric. ASSEMBLYPARTS Instructions apply to Part Number 9392-131 Poles (4) Part No. 9392-2101 Hub (1) Part No. 9392-1071 Illus. 2 Screen House laid out in position with partially assembled frame locked into hub. Illus. 1 Poles inserted into hub Hub Hub Frame Clips2 3 PRINTED IN SRI LANKARev. 11/04 Things You Should Know • Never store shelter, even for a short period of time, without drying it thoroughly and brushing off caked dirt. Do not pack stakes or poles inside your shelter. Use separate storage bag. • STAKES SHOULD BE REMOVED BYPULLING ON THE STAKE ITSELF. NEVER PULLON THE SHELTER FABRIC OR STAKE LOOPTO REMOVE STAKE. • SHELTER POLES SHOULD NOTBE LEFTTELESCOPED TOGETHER DURING STORAGE. • Do not leave your shelter set-up for weeks at a time, be aware that exposure to the ultraviolet rays of the sun can seriously damage material and/or cause it to become discolored. WARNING:Keep all flame and heat sources away from this shelter fabric. This shelter meets the flammability requirements of CPAI-84. The fabric will burn if left in continuous contact with any flame source. The application of any foreign substance to the shelter fabric may render the flame-resistant properties ineffective. THE COLEMAN CO., INC. 3600 N. Hydraulic • Wichita, Kansas 67219 1-800-835-3278 • www.coleman.com MADE IN SRI LANKA Attach Shelter to Frame – With the frame still partially set up, clip the center of the Screen House to the center hub. (illus. 3) – Starting towards the center of the Screen House, clip the shelter fabric to the poles. Complete Shelter – Fully extend each pole by straightening all shock-corded pole sections. – Insert the pin on the pin and ring system, at the corner of the Screen House into the the pole end. (illus. 4), (illus. 6) – Repeat for remaining poles. – Adjust poles to pull the shelter taut and stake down through the fabric loops at the end of pin and ring. (illus. 5), (illus. 6) – Attach guy lines to fabric guy loops at each corner and stake out. (illus. 6) illus. 3 Screen House clipped to partially assembled frame Start by attaching the center of the Screen House to the pole hub. illus. 4 Insert into the pole end illus. 6 Completed shelter with guy lines staked out illus. 5 Stake through stake loop »