Notice MARMITEK CM15Pro

« the product or when the product is used for purposes other than specified. Marmitek does not accept responsibility for additional damage other than covered by the legal product respon- sibility. •This product is not a toy. Keep out of reach of children. •Do not open the product (battery panel excepted): the device may contain live parts. The product should only be repaired or serviced by a qualified repairman. •Keep batteries out of the reach of children. Dispose of batteries as chemical waste. Never use old and new batteries or different types of batteries together. Remove the batteries when you are not using the system for a longer period of time. Check the polarity (+/-) of the bat- teries when inserting them in the product. Wrong positioning can cause an explosion. •Only connect the adapter to the mains after checking whether the mains voltage is the same as the values on the identification tags. Never connect an adapter or power cord when it is damaged. In that case, contact your supplier. •Automatic switching devices provide comfort, but can also be dangerous. They can surprise people or can ignite clothing hanging over an electric heat source. Please be careful and take appropriate measures to avoid accidents. HOW DOES MARMITEK X-10 WORK? Marmitek X-10 components use the existing mains wiring to communicate (using Marmitek X-10 signals). You can build a complete system using the three different kind of components of the Marmitek X-10 System: 1.ModulesThese components will receive Marmitek X-10 signals and will switch or dim the attached lamp or appliance. Examples of these modules are lamp modules and appliance modules. These are available as build-in, micro, DIN rail and plug-in modules. 2.ControllersThese components will transmit Marmitek X-10 signals and thus will control the Modules. 3.Transmitters Wireless components like remotes. The signals of these components will be received by a controller with transceiver functionality (IRRF 7243, 3CM15Pro™ + ActiveHome Pro™ ENGLISHTM13 or CM15Pro). The Transceiver will translate the signals into Marmitek X-10 signals on the power line. ADRESSES Up to a maximum of 256 different addresses can be preset. These are subdivided into a so-called HouseCode (A to P incl.) and a UnitCode (1 to 16 incl.). The HouseCode can also be set on the controllers, so that the controllers and modules become part of the same system. The address can be set either using code dials or by pressing buttons, depending on the type of module. The Marmitek X-10 System uses standard commands, which control all units with the same HouseCode at the same time (e.g. all lights on, all off, etc.). SIGNAL RANGE Range of Marmitek X-10 signals over the Power Line and how to increase the range. The Marmitek X-10 System is based on power line communication. The range of the Marmitek X-10 signals very much depends on the local circumstances. On average the range is a cable length of 80 meters. If you have difficulties with the range of your Marmitek X-10 signals, please pay attention to the following facts: 1.When more than one phase is used for your electrical system, it is necessary to cou- ple these phases for the Marmitek X-10 signals. For coupling you can use FD10 Phase Couplers/Filters. You only need to install a Phase Coupler/Filter when your wall outlets and light switches are divided over more than one phase (more than one group is no problem). For bigger... »