Notice SONY SAL-50M28

« health, which could otherwise be caused by inappropriate waste handling of this product. The recycling of materials will help to conserve natural resources. For more detailed information about recycling of this product, please contact your local Civic Of?ce, your household waste disposal service or the shop where you purchased the product. For the customers in the U.S.A. THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. CAUTION You are cautioned that any changes or modi?cations not expressly approved in this manual could void your authority to operate this equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: – Reorient or relocate the receiving antenna. – Increase the separation between the equipment and receiver. – Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. – Consult the dealer or an experienced radio/TV technician for help. For the customers in Canada This Class B digital apparatus complies with Canadian ICES-003. Notes on use • Do not leave the lens in direct sunlight. If sunlight is focused onto a nearby object, it may cause a ?re. If circumstances necessitate leaving the lens in direct sunlight, be sure to attach the lens cap. • Be careful not to subject the lens to mechanical shock while attaching it. • Always place the lens caps on the lens when storing. • Do not keep the lens in a very humid place for a long period of time to prevent mold. • After attaching the lens, do not carry the camera by holding the lens. • Do not touch the lens contacts. If dirt, etc., gets on the lens contacts, it may interfere or prevent the sending and receiving of signals between the lens and the camera, resulting in operational malfunction. Precaution for ?ash use With certain of lens/?ash combinations, the lens may partially block the light of the ?ash, resulting in a shadow at the bottom of the picture. When using a built-in camera ?ash, make sure to remove the lens hood and shoot from at least 1m (3.3feet) away from your subject. Vignetting When you use lens, the corners of the screen become darker than the center. To reduce this phenomena (called vignetting), close the aperture by 1 to 2 stops. Condensation If your lens is brought directly from a cold place to a warm place, condensation may appear on the lens. To avoid this, place the lens in a plastic bag or something similar. When the air temperature inside the bag reaches the sur... »