Notice D-LINK DAP-2360

« ion 7.0 or Firefox 3.0 and above 1. Package Contents ?DAP-2360 802.11n Access Point ?Manual and Software on CD-ROM ?Power Adapter ?Mounting Plate ?Ethernet Cable If any of the above items are missing, please contact your reseller. Safety Notice: Installation and servicing should be done by certi?ed technicians so as to conform to all local codes and prevent voiding your warranty. ?'D-Link DAP-2360 Quick Install Guide 3 ENGLISH RESET LAN(PoE)5V 2.5A 2. Hardware Overview 3. Hardware Installation LAN - Solid light when the Ethernet port is connected to a working port, such as a router or switch. The light will blink when there is traffic through LAN port. 2.4 GHz - When lit, the access point is operating at 2.4GHz. This light will blink when there is wireless traffic. POWER - The light will blink during boot up. Once solid, the access point is ready. Antennas Power Receptor Reset LAN Port (PoE) ?'D-Link DAP-2360 Quick Install Guide4 ENGLISH To power the access point, you can use one of the following methods: 1. Use the supplied power adapter 2. Connect one end of your Ethernet cable into the LAN (PoE) port on the DAP-2360 and the other end into one port on a PoE switch. To setup and manage the DAP-2360 from a computer, use one of the following methods: 1. Connect a straight through Ethernet cable between the access point and your computer. 2. Connect the access point to a switch or router and use a computer from a computer that is also connected to that switch or router. 3. Please start your web browser program, type the IP address of the device (http://192.168.0.50) and press Enter. Make sure that the IP addresses of the device and your computer are in the same subnet. Then, refer to the Manual for con?guration. OR Computer PoE Switch DAP-2360 ?'D-Link DAP-2360 Quick Install Guide5 ENGLISH 4. Mounting Plate Assembly Step 1: Insert provided wall anchors in the wall where the mounting plate will be attached. Step 2: Use the provided screws to secure the mounting plate on the wall. Step 3: Attach the remaining screws securely to the back of the DAP-2360. Step 4: Attach the DAP-2360 to the mounting plate. Step 5: Slide the DAP-2360 down into the grooves on the mounting plate to secure it to the plate. ?'D-Link DAP-2360 Quick Install Guide6 ENGLISH 5. Your Setup is Complete When you have completed the steps in this Installation Guide and con?gured your for your network, your network should look similar to this: * Maximum Wireless signal rate derived from IEEE 802.11n speci?cations. Actual data throughput will vary. Network conditions and environmental factors, including volume of network traf?c, building materials and construction, and network overhead lower actual data throughput rate. T1 RADIU Server Computer 3 with Wireless N Adapter Computer 1 with Wireless N Adapter Computer 2 with Wireless N Adapter Computer 5 with Wireless N Adapter Computer 6 with Wireless N Adapter Computer 7 with Wireless N Adapter Computer 8 with Wireless N Adapter Computer 9 with Wireless N Adapter Computer 10 with Wireless N Adapter Computer 4 with Wireless N Adapter PoE Switch Business-class Router Managed... »