Notice SONY SRSBTM8

« g call. AUDIO IN jack Connects to the headphone jack of a portable audio device, computer, etc., using a connecting cord (not supplied). DC IN 6V jack Connects the supplied AC adaptor. Battery compartment Insert four alkaline LR6 (size AA) batteries (not supplied). Indications of the Bluetooth function Status (Bluetooth) indicator (blue) Pairing with a deviceFlashes quickly Searching for a deviceFlashes Connected to a deviceLights up Turning the System on/off 1 Connect the supplied AC adaptor. 2 Press the Ò/Æ button. The OPR/BATT indicator (green) lights up. Indicator lights up. To use with LR6 (size AA) batteries (not supplied) 1 Open the cover located on the bottom of the system and install four alkaline LR6 (size AA) batteries (not supplied), then close the cover. C 2 Press the Ò/Æ button. Note ? If the AC adaptor is used with the system, the power source switches to the wall outlet (mains) automatically, even if batteries are installed. Installed batteries cannot be the power source when the AC adaptor is connected to the system. Make sure the plug of the AC adaptor is disconnected from the system when using the system with batteries. How to Make Wireless Connection with Bluetooth Devices You can enjoy music and hands-free calling with the system wirelessly by using your device’s Bluetooth function. Choose one of the following three connection methods, best suited for the Bluetooth device. For details on how to operate your device, refer to the operating instructions supplied with the device. Pairing with a Bluetooth device: see Pattern A Bluetooth devices need to be “paired” with each other beforehand. Connecting with a paired device: see Pattern B To listen to music with a Bluetooth device that has been paired, see this pattern. One touch connection with a smartphone (NFC): see Pattern C Using an NFC compatible smartphone, you can establish a Bluetooth connection by just touching the system with it. Check the following before operating the system. ? Both the system and the device are placed within 1 m of each other. ? The system is connected to a power source, or batteries are installed in the system. ? The operating instructions supplied with the device are kept at hand. Pattern A Pairing and connecting with a Bluetooth device 1 Turn on the system. 2 Set the Bluetooth function of the Bluetooth device to on. For details, refer to the operating instructions supplied with the device. 3 Press and hold the BLUETOOTH PAIRING button on the system until beeps are heard and the (Bluetooth) indicator (blue) begins to flash quickly. Tip ? When the system is turned on first, the (Bluetooth) indicator (blue) starts flashing quickly. Indicator flashes quickly. 4 Perform the pairing procedure on the Bluetooth device to detect the system. If “SRS-BTM8” does not appear on the device’s display, repeat from step 2. Note ? Some devices cannot display a list of detected devices. 5 Select “SRS-BTM8” shown in the display of the Bluetooth device. 6 If Passcode* input is required on the display of the Bluetooth device, input “0000.” The Bluetooth connection is established and the (Bluetooth) indicator (blue) on the system stays on. * Passcode may be called “Passkey,” “PIN code,” “PIN number,” or “Password.” Tip ? To pair with other Bluetooth devices, repeat steps 2 to 6 for each device. Notes ? Pairing mode of the system is cancelled after about 5 minutes, and the (Bluetooth) indic... »